If you are always complaining that you are too spread, are overwhelmed with the job at hand, and struggle to figure out how to prioritize your efforts, these would be the basic problem of low efficiency and production. You will never doubt anymore with our 350-401 Valid Exam Vce Free test prep. Moreover for all your personal information, we will offer protection acts to avoid leakage and virus intrusion so as to guarantee the security of your privacy. Although we cannot contact with each other face to face, but there are no disparate treatments and we treat every customer with consideration like we are around you at every stage during your review process on our 350-401 Valid Exam Vce Free exam questions. We will offer help insofar as I can. Our 350-401 Valid Exam Vce Free quiz torrent was designed by a lot of experts and professors in different area in the rapid development world.
CCNP Enterprise 350-401 And you will have the demos to check them out.
CCNP Enterprise 350-401 Valid Exam Vce Free - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) As the talent team grows, every fighter must own an extra technical skill to stand out from the crowd. And we will try our best to satisfy our customers with better quatily and services. Our loyal customers give our Valid 350-401 Test Camp File exam materials strong support.
How to get the test 350-401 Valid Exam Vce Free certification in a short time, which determines enough qualification certificates to test our learning ability and application level. This may be a contradiction of the problem, we hope to be able to spend less time and energy to take into account the test 350-401 Valid Exam Vce Free certification, but the qualification examination of the learning process is very wasted energy, so how to achieve the balance? Our 350-401 Valid Exam Vce Free exam prep can be done with its high-efficient merit. Try it now!
Cisco 350-401 Valid Exam Vce Free - Trust us and give yourself a chance to success!
Our 350-401 Valid Exam Vce Free training materials are regarded as the most excellent practice materials by authority. Our company is dedicated to researching, manufacturing, selling and service of the 350-401 Valid Exam Vce Free study guide. Also, we have our own research center and experts team. So our products can quickly meet the new demands of customers. That is why our 350-401 Valid Exam Vce Free exam questions are popular among candidates. we have strong strenght to support our 350-401 Valid Exam Vce Free practice engine.
There are so many advantages of our 350-401 Valid Exam Vce Free actual exam, and you are welcome to have a try! We have put substantial amount of money and effort into upgrading the quality of our 350-401 Valid Exam Vce Free preparation materials, into our own 350-401 Valid Exam Vce Free sales force and into our after sale services.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
Huawei H13-821_V3.0-ENU - Time is flying and the exam date is coming along, which is sort of intimidating considering your status of review process. No other HP HPE0-V28-KR study materials or study dumps can bring you the knowledge and preparation that you will get from the HP HPE0-V28-KR study materials available only from Omgzlook. Splunk SPLK-5002 - It will add more colors to your life. Our experts have great familiarity with Juniper JN0-664 real exam in this area. Omgzlook will provide all the latest and accurate exam practice questions and answers for the staff to participate in Oracle 1z1-808-KR certification exam.
Updated: May 28, 2022