Never feel sorry to invest yourself. Our H31-161 Reliable Test Pattern exam materials deserve your choice. If you still cannot make decisions, you can try our free demo of the H31-161 Reliable Test Pattern training quiz. You can much more benefited form our H31-161 Reliable Test Pattern study guide. Don't hesitate, it is worthy to purchase! To choose us is to choose success!
HCIE-Carrier IP H31-161 So your error can be corrected quickly.
HCIE-Carrier IP H31-161 Reliable Test Pattern - HCIE-Carrier IP (Written) We hope to grow with you and help you get more success in your life. Many students often complain that they cannot purchase counseling materials suitable for themselves. A lot of that stuff was thrown away as soon as it came back.
Our passing rate may be the most attractive factor for you. Our H31-161 Reliable Test Pattern learning guide have a 99% pass rate. This shows what? As long as you use our products, you can pass the exam!
Huawei H31-161 Reliable Test Pattern - So, buy our products immediately!
We offer free demos of the H31-161 Reliable Test Pattern exam braindumps for your reference before you pay for them, for there are three versions of the H31-161 Reliable Test Pattern practice engine so that we also have three versions of the free demos. And we will send you the new updates if our experts make them freely. On condition that you fail the exam after using our H31-161 Reliable Test Pattern study guide unfortunately, we will switch other versions for you or give back full of your refund. All we do and the promises made are in your perspective.
They have rich experience in predicating the H31-161 Reliable Test Pattern exam. Then you are advised to purchase the study materials on our websites.
H31-161 PDF DEMO:
QUESTION NO: 1
When the multicast source starts to send multicast data and no receiver joins in the RP in PIM-
SM, which of the following statements are true?
A. After all sources unicast registration information to the RP, no multicast route entries related to source groups are generated due to receiver absence.
B. After receiving a registration message, the RP creates the multicast routing entries (*, G) of all source groups and sends a register stop message to the source DR.
C. The RP receives a registration message from the source DR, creates a multicast routing entry (S,
G), and sends a register stop message to the source DR.
D. After the source DR unicasts registration information to the RP, the multicast routing entries (S, G) of all source groups are generated in the RP but the outbound interface is null.
Answer: C,D
QUESTION NO: 2
As shown in the figure, MPLS, MPLS TE, and MPLS RSVP-TE are configured on RTA, RTB, RTC, and RTD. Tunnel1/0/0 and Tunnel2/0/0 are set up based on the explicit path RTA-RTB-RTC.
Tunnel1/0/0 has a hot-standby path (RTA-RTD-RTC) and an FRR path: RTA-RTD-RTC, whereas
Tunnel2/0/0 has an ordinary path (RTA-RTD-RTC) and an FRR path. Which of the following statements are true?
A. When the link between RTA and RTB is faulty, the state of Tunnel1/0/0 is hotstanby inuse.
B. When the link between RTB and RTC is faulty, the state of Tunnel2/0/0 is ordinary inuse.
C. When the link between RTA and RTB is faulty, the state of Tunnel2/0/0 is ordinary inuse.
D. When the link between RTA and RTB is faulty, the state of Tunnel2/0/0 is FRR inuse.
Answer: A,D
QUESTION NO: 3
Which of the following can be implemented in an IP backbone network?
A. BGP
B. MPLS
C. RIP
D. ISIS
Answer: A,B,D
QUESTION NO: 4
Refer to the exhibit.
As shown in the figure, RT 5 is a stub area router, an external Internet route is imported by RT 1, and a virtual connection is established between RT 1 and RT 3.At present, the Internet is accessible to routers except RT 5. Why can the Internet not be accessed from RT 5?(Select two answers)
A. The cost of the link between RT 1 and RT 3 is excessively large.
B. A stub area cannot be connected using a virtual link.
C. RT1 does not inform RT 5 that category 3 LSAs are configured by default.
D. Category 5 LSAs cannot be sent in a stub area.
Answer: A,C
QUESTION NO: 5
#
pim
c-rp Ethernet6/2/0
timer hello 100
state-refresh-interval 10
state-refresh-ttl 60
Interface Ethernet6/2/0Ip address 20.1.1.3 255.255.255.0
Pim timer hello 45
Pim dm
#
Which of the following statements are false?
A. If the PIM-DM is enabled at Ethernet 6/2/0 on a router, the PIM-SM cannot be enabled at other interfaces on the router.
B. Ethernet 6/2/0 sends a state-refresh message every 10 seconds.
C. Ethernet 6/2/0 sends a PIM hello message every 100 seconds.
D. The TTL value is 60 in state-refresh messages sent by the router.
Answer: B,C
With years of experience dealing with Microsoft PL-500 learning engine, we have thorough grasp of knowledge which appears clearly in our Microsoft PL-500 study quiz with all the keypoints and the latest questions and answers. IBM C1000-127 - Now IT industry is more and more competitive. Just come to buy our IBM S2000-020 learning guide and you will love it. If you are still struggling to prepare for passing HP HP2-I73 certification exam, at this moment Omgzlook can help you solve problem. Free demos are understandable and part of the IBM C1000-169 exam materials as well as the newest information for your practice.
Updated: May 27, 2022