As a representative of clientele orientation, we promise if you fail the practice exam after buying our 350-401 Test Collection File training quiz, we will give your compensatory money full back. We keep raising the bar of our 350-401 Test Collection File real exam for we hold the tenet of clientele orientation. According to former exam candidates, more than 98 percent of customers culminate in success by their personal effort as well as our 350-401 Test Collection File study materials. If our candidates have other things, time is also very valuable. It is very difficult to take time out to review the 350-401 Test Collection File exam. There is no doubt that you can get a great grade.
CCNP Enterprise 350-401 It is very easy and convenient to use and find.
As the employment situation becoming more and more rigorous, it’s necessary for people to acquire more 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Test Collection File skills and knowledge when they are looking for a job. Their masterpieces are instrumental to offer help and improve your performance in the real exam. Being dedicated to these practice materials painstakingly and pooling useful points into our Practice 350-401 Questions exam materials with perfect arrangement and scientific compilation of messages, our Practice 350-401 Questions practice materials can propel the exam candidates to practice with efficiency.
There is an old saying goes, good memory is inferior to sodden ability to write, so we believe that it is a highly productive way for you to memory the knowledge point and review the reference books more effectively. Besides our 350-401 Test Collection File exam torrent support free demo download, as we mentioned before, it is an ideal way for you to be fully aware of our 350-401 Test Collection File prep guide and then purchasing them if suitable and satisfactory. There is no doubt that among our three different versions of 350-401 Test Collection File guide torrent, the most prevalent one is PDF version, and this is particularly suitable and welcomed by youngsters.
We believe that you will like our Cisco 350-401 Test Collection File exam prep.
With three versions of products, our 350-401 Test Collection File learning questions can satisfy different taste and preference of customers with different use: PDF & Software & APP versions. Without ambiguous points of questions make you confused, our 350-401 Test Collection File practice materials can convey the essence of the content suitable for your exam. With our 350-401 Test Collection File exam guide, you will achieve what you are expecting with ease.
You can take the 350-401 Test Collection File training materials and pass it without any difficulty. Now is not the time to be afraid to take any more difficult 350-401 Test Collection File certification exams.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
If you want to get the ISM CORe certification to improve your life, we can tell you there is no better alternative than our ISM CORe exam questions. And if you still don't believe what we are saying, you can log on our platform right now and get a trial version of VMware 2V0-33.22PSE study engine for free to experience the magic of it. With our Microsoft DP-203-KR learning materials for 20 to 30 hours, we can claim that you will be confident to go to write your Microsoft DP-203-KR exam and pass it. Every day we are learning new knowledge, but also constantly forgotten knowledge before, can say that we have been in a process of memory and forger, but how to make our knowledge for a long time high quality stored in our minds? This requires a good memory approach, and the SAP C-THR83-2405 study braindumps do it well. Our ARDMS SPI learning material is prepared by experts in strict accordance with the exam outline of the ARDMS SPI certification exam, whose main purpose is to help students to pass the exam with the least amount of time and effort.
Updated: May 28, 2022