Using our 350-401 Simulator Fee study braindumps, you will find you can learn about the knowledge of your exam in a short time. Because you just need to spend twenty to thirty hours on the practice exam, our 350-401 Simulator Fee study materials will help you learn about all knowledge, you will successfully pass the 350-401 Simulator Fee exam and get your certificate. So if you think time is very important for you, please try to use our 350-401 Simulator Fee study materials, it will help you save your time. Our 350-401 Simulator Fee materials provide you with the best learning prospects and give you more than you expect by adopting minimal effort. Perhaps the path to successful pass the 350-401 Simulator Fee is filled variables, but now there is only one possibility to successfully obtain a 350-401 Simulator Fee certification. 350-401 Simulator Fee exam materials provide you the best learning prospects, by employing minimum exertions through the results are satisfyingly surprising, beyond your expectations.
CCNP Enterprise 350-401 Time and tide wait for no man.
However, how to pass Cisco certification 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Simulator Fee exam quickly and simply? Our Omgzlook can always help you solve this problem quickly. Our 350-401 Valid Exam Study Guide practice materials are suitable to exam candidates of different levels. And after using our 350-401 Valid Exam Study Guide learning prep, they all have marked change in personal capacity to deal with the 350-401 Valid Exam Study Guide exam intellectually.
Through so many feedbacks of these products, our Omgzlook products prove to be trusted. Omgzlook have the latest Cisco certification 350-401 Simulator Fee exam training materials. The industrious Omgzlook's IT experts through their own expertise and experience continuously produce the latest Cisco 350-401 Simulator Fee training materials to facilitate IT professionals to pass the Cisco certification 350-401 Simulator Fee exam.
Cisco 350-401 Simulator Fee - We get first-hand information; 2.
Perhaps you have wasted a lot of time to playing computer games. It doesn’t matter. It is never too late to change. There is no point in regretting for the past. Our 350-401 Simulator Fee exam questions can help you compensate for the mistakes you have made in the past. You will change a lot after learning our 350-401 Simulator Fee study materials. And most of all, you will get reward by our 350-401 Simulator Fee training engine in the least time with little effort.
As we sell electronic files, there is no need to ship. After payment you can receive 350-401 Simulator Fee exam review questions you purchase soon so that you can study before.
350-401 PDF DEMO:
QUESTION NO: 1
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 2
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 3
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
ASQ CQE - There is no doubt that the certification has become more and more important for a lot of people, especial these people who are looking for a good job, and it has been a general trend. Salesforce Salesforce-MuleSoft-Developer-I - Please totally trust the accuracy of questions and answers. After a long period of research and development, our SAP E-S4CPE-2023 test questions have been the leader study materials in the field. Expert for one-year free updating of SAP C_TS462_2022-KR dumps pdf, we promise you full refund if you failed exam with our dumps. And you can free download the demos of the CWNP CWNA-109 learning quiz.
Updated: May 28, 2022