Cisco 350-401최신시험 덤프결제에 관하여 불안정하게 생각되신다면 paypal에 대해 알아보시면 믿음이 생길것입니다. 더욱 안전한 지불을 위해 저희 사이트의 모든 덤프는paypal을 통해 지불을 완성하게 되어있습니다. Paypal을 거쳐서 지불하면 저희측에서Cisco 350-401최신시험덤프를 보내드리지 않을시 paypal에 환불신청하실수 있습니다. 고득점으로 패스하시면 지인분들께 추천도 해주실거죠? Omgzlook에서 제공해드리는 Cisco인증 350-401최신시험덤프는 가장 출중한Cisco인증 350-401최신시험시험전 공부자료입니다. 우리Omgzlook가 제공하는 최신, 최고의Cisco 350-401최신시험시험관련 자료를 선택함으로 여러분은 이미 시험패스성공이라고 보실수 있습니다.
CCNP Enterprise 350-401 하지만 여러분의 선택에 따라 보장도 또한 틀립니다.
Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)최신시험시험을 패스하려면Omgzlook가 고객님의 곁을 지켜드립니다. 요즘같이 시간인즉 금이라는 시대에 시간도 절약하고 빠른 시일 내에 학습할 수 있는 Omgzlook의 덤프를 추천합니다. 귀중한 시간절약은 물론이고 한번에Cisco 350-401 인기덤프인증시험을 패스함으로 여러분의 발전공간을 넓혀줍니다.
Cisco 350-401최신시험 시험을 한번에 합격할수 없을가봐 두려워 하고 계시나요? 이 글을 보고 계신 분이라면 링크를 클릭하여 저희 사이트를 방문해주세요. 저희 사이트에는Cisco 350-401최신시험 시험의 가장 최신 기출문제와 예상문제를 포함하고 있는 Cisco 350-401최신시험덤프자료를 제공해드립니다.덤프에 있는 문제와 답을 완벽하게 기억하시면 가장 빠른 시일내에 가장 적은 투자로 자격증 취득이 가능합니다.
Cisco 350-401최신시험 - 시험패스가 한결 편해집니다.
최근들어 Cisco 350-401최신시험시험이 큰 인기몰이를 하고 있는 가장 핫한 IT인증시험입니다. Cisco 350-401최신시험덤프는Cisco 350-401최신시험시험 최근문제를 해석한 기출문제 모음집으로서 시험패스가 한결 쉬워지도록 도와드리는 최고의 자료입니다. Cisco 350-401최신시험인증시험을 패스하여 자격증을 취득하면 보다 쉽고 빠르게 승진할수 있고 연봉인상에도 많은 도움을 얻을수 있습니다.
IT업계 취업 준비생이라면 국제적으로도 승인받는 IT인증자격증 정도는 몇개 취득해야 하지 않을가 싶습니다. Cisco인증 350-401최신시험시험을 통과하여 인기 자격증을 취득하시면 취업경쟁율이 제고되어 취업이 쉬워집니다.
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
여러분은 아주 빠르게 안전하게 또 쉽게Cisco Microsoft AZ-400인증시험 자격증을 취득하실 수 있습니다. Cisco Salesforce ANC-301시험대비덤프는 IT업계에 오랜 시간동안 종사한 전문가들의 노하우로 연구해낸 최고의 자료입니다. Omgzlook는 여러분의 전업지식을 업그레이드시켜줄 수 잇고 또한 한번에Cisco인증SAP C-S4TM-2023시험을 패스하도록 도와주는 사이트입니다. Omgzlook는 여러분이 안전하게Cisco Microsoft MB-260시험을 패스할 수 있는 최고의 선택입니다. SAP C-S4TM-2023 - IT시험이라고 모두 무조건 외우고 장악하고 많은 시간을 투자해야만 된다는 사상을 깨게 될 것입니다.
Updated: May 28, 2022