Cisco인증 350-401참고덤프덤프공부가이드로 시험준비공부를 하시면 시험패스가 쉬워집니다. 공부하는 시간도 적어지고 다른 공부자료에 투자하는 돈도 줄어듭니다. Omgzlook의Cisco인증 350-401참고덤프덤프는 Cisco인증 350-401참고덤프시험패스의 특효약입니다. Omgzlook의Cisco인증 350-401참고덤프덤프를 공부하시면 한방에 시험을 패스하는건 문제가 아닙니다. Omgzlook의Cisco인증 350-401참고덤프덤프는 시험적중율 최고의 인지도를 넓히 알리고 있습니다.저희가 제공한 시험예상문제로 시험에 도전해보지 않으실래요? Cisco인증 350-401참고덤프덤프를 선택하시면 성공의 지름길이 눈앞에 다가옵니다. Omgzlook덤프로 가볼가요?
CCNP Enterprise 350-401 고객님의 최근의 꿈은 승진이나 연봉인상이 아닐가 싶습니다.
Omgzlook에서 출시한 Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)참고덤프덤프는Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)참고덤프시험에 대비하여 IT전문가들이 제작한 최신버전 공부자료로서 시험패스율이 100%입니다.Omgzlook는 고품질 Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)참고덤프덤프를 가장 친근한 가격으로 미래의 IT전문가들께 제공해드립니다. Omgzlook의Cisco인증 350-401 최신기출자료시험덤프 공부가이드는 시장에서 가장 최신버전이자 최고의 품질을 지닌 시험공부자료입니다.IT업계에 종사중이라면 IT자격증취득을 승진이나 연봉협상의 수단으로 간주하고 자격증취득을 공을 들여야 합니다.회사다니면서 공부까지 하려면 몸이 힘들어 스트레스가 많이 쌓인다는것을 헤아려주는Omgzlook가 IT인증자격증에 도전하는데 성공하도록Cisco인증 350-401 최신기출자료시험대비덤프를 제공해드립니다.
Omgzlook 에서Cisco 350-401참고덤프 덤프를 구매하시면 일년무료 업데이트서비스를 받을수 있습니다.일년무료 업데이트서비스란 구매일로부터 1년동안 구매한 덤프가 업데이트될때마다 구매시 사용한 메일주소로 가장 최신버전을 보내드리는것을 의미합니다. Cisco 350-401참고덤프덤프에는 가장 최신시험문제의 기출문제가 포함되어있어 높은 적주율을 자랑하고 있습니다.
Cisco Cisco 350-401참고덤프시험준비중이신 분이시라면Cisco Cisco 350-401참고덤프한번 믿고 시험에 도전해보세요.
저희 Omgzlook의 덤프 업데이트시간은 업계에서 가장 빠르다고 많은 덤프구매자 분들께서 전해주셨습니다. Cisco 350-401참고덤프 덤프도 마찬가지 입니다. 저희는 수시로 덤프업데이트 가능성을 체크하여 덤프를 항상 시중에서 가장 최신버전이 될수있도록 최선을 다하고 있습니다. 구매후 1년무료업데이트서비스를 해드리기에 구매후에도 덤프유효성을 최대한 연장해드립니다.
이는 응시자가 확실하고도 빠르게Cisco 350-401참고덤프덤프를 마스터하고Cisco 350-401참고덤프시험을 패스할수 있도록 하는 또 하나의 보장입니다. 매력만점Cisco 350-401참고덤프덤프 강력 추천합니다.
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
체험 후Omgzlook 에서 출시한Cisco Salesforce Platform-App-Builder덤프에 신뢰감을 느끼게 될것입니다. Omgzlook 의 학습가이드에는Cisco SAP C-S4CPR-2402인증시험의 예상문제, 시험문제와 답입니다. 만약 Cisco ECCouncil 112-51 덤프자료를 구매하여 공부한후 시험에 탈락할시 불합격성적표와 주문번호를 메일로 보내오시면 덤프비용을 바로 환불해드립니다. 여러분이 다른 사이트에서도Cisco인증Fortinet FCP_FML_AD-7.4시험 관련덤프자료를 보셨을 것입니다 하지만 우리Omgzlook의 자료만의 최고의 전문가들이 만들어낸 제일 전면적이고 또 최신 업데이트일 것입니다.우리덤프의 문제와 답으로 여러분은 꼭 한번에Cisco인증Fortinet FCP_FML_AD-7.4시험을 패스하실 수 있습니다. Omgzlook는 전문적인 IT인증시험덤프를 제공하는 사이트입니다.IBM C1000-162인증시험을 패스하려면 아주 현병한 선택입니다.
Updated: May 28, 2022