Omgzlook는Omgzlook의Cisco인증 350-401인기시험덤프자료를 공부하면 한방에 시험패스하는것을 굳게 약속드립니다. Omgzlook의Cisco인증 350-401인기시험덤프로 공부하여 시험불합격받으면 바로 덤프비용전액 환불처리해드리는 서비스를 제공해드리기에 아무런 무담없는 시험준비공부를 할수 있습니다. 노력하지 않고야 당연히 불가능한 일이 아니겠습니까? Cisco 인증350-401인기시험 시험은 기초 지식 그리고 능숙한 전업지식이 필요 합니다. Omgzlook는 여러분들한테Cisco 인증350-401인기시험시험을 쉽게 빨리 패스할 수 있도록 도와주는 사이트입니다. Omgzlook 덤프를 구매하시면 이제 그런 고민은 끝입니다.
CCNP Enterprise 350-401 IT인증자격증을 취득하려고 마음먹었으면 끝까지 도전해봐야 합니다.
Omgzlook에서는 여러분이 안전하게 간단하게Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)인기시험시험을 패스할 수 있는 자료들을 제공함으로 빠른 시일 내에 IT관련지식을 터득하고 한번에 시험을 패스하실 수 있습니다. 데모도 pdf버전과 온라인버전으로 나뉘어져 있습니다.pdf버전과 온라인버전은 문제는 같은데 온라인버전은 pdf버전을 공부한후 실력테스트 가능한 프로그램입니다. Omgzlook에서 출시한 Cisco 350-401 시험자료덤프만 있으면 학원다닐 필요없이 시험패스 가능합니다.
어쨌든 개인적인 지식 장악도 나 정보기술 등을 테스트하는 시험입니다. 보통은Cisco인증350-401인기시험시험을 넘기 위해서는 많은 시간과 신경이 필요합니다. Cisco인증350-401인기시험시험은 현재 치열한 IT경쟁 속에서 열기는 더욱더 뜨겁습니다.
Cisco Cisco 350-401인기시험 덤프를 한번 믿고Cisco Cisco 350-401인기시험시험에 두려움없이 맞서보세요.
Cisco 인증 350-401인기시험시험이 너무 어려워서 시험 볼 엄두도 나지 않는다구요? Omgzlook 덤프만 공부하신다면 IT인증시험공부고민은 이젠 그만 하셔도 됩니다. Omgzlook에서 제공해드리는Cisco 인증 350-401인기시험시험대비 덤프는 덤프제공사이트에서 가장 최신버전이여서 시험패스는 한방에 갑니다. Cisco 인증 350-401인기시험시험뿐만 아니라 IT인증시험에 관한 모든 시험에 대비한 덤프를 제공해드립니다. 많은 애용 바랍니다.
Cisco 350-401인기시험 시험 기출문제를 애타게 찾고 계시나요? Omgzlook의 Cisco 350-401인기시험덤프는Cisco 350-401인기시험최신 시험의 기출문제뿐만아니라 정답도 표기되어 있고 저희 전문가들의 예상문제도 포함되어있어 한방에 응시자분들의 고민을 해결해드립니다. 구매후 시험문제가 변경되면 덤프도 시험문제변경에 따라 업데이트하여 무료로 제공해드립니다.
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
Cisco인증 EMC D-VXR-OE-23시험을 패스하려면 Omgzlook의Cisco인증 EMC D-VXR-OE-23덤프로 시험준비공부를 하는게 제일 좋은 방법입니다. Adobe AD0-E716 - Omgzlook의 자료만의 제일 전면적이고 또 최신 업데이트일것입니다. EMC D-VXR-DY-01 - Omgzlook의 인지도는 고객님께서 상상하는것보다 훨씬 높습니다.많은 분들이Omgzlook의 덤프공부가이드로 IT자격증 취득의 꿈을 이루었습니다. Omgzlook는 여러분이 한번에Cisco인증SAP C-WZADM-2404시험을 패스하도록 하겠습니다. 시험문제가 변경되면 업데이트 하도록 최선을 다하기에Omgzlook의 Cisco인증 PMI PMP덤프의 유효기간을 연장시켜드리는 셈입니다.퍼펙트한 구매후는 서비스는Omgzlook의 Cisco인증 PMI PMP덤프를 구매하시면 받을수 있습니다.
Updated: May 28, 2022