덤프는 구체적인 업데이트주기가 존재하지 않습니다. 하지만 저희는 수시로 Cisco 350-401시험응시 시험문제 변경을 체크하여Cisco 350-401시험응시덤프를 가장 최신버전으로 업데이트하도록 최선을 다하고 있습니다. Cisco 350-401시험응시덤프를 구매하면 1년간 업데이트될떼마다 최신버전을 구매시 사용한 메일로 전송해드립니다. 마침 우리Omgzlook 의 문제와 답들은 모두 이러한 과정을 걸쳐서 만들어진 아주 완벽한 시험대비문제집들입니다. 우리의 문제집으로 여러분은 충분히 안전이 시험을 패스하실 수 있습니다. Cisco 350-401시험응시덤프의 문제와 답은 모두 엘리트한 인증강사 및 전문가들에 의하여 만들어져Cisco 350-401시험응시 시험응시용만이 아닌 학습자료용으로도 손색이 없는 덤프입니다.저희 착한Cisco 350-401시험응시덤프 데려가세용~!
CCNP Enterprise 350-401 Omgzlook는 아주 믿을만하고 서비스 또한 만족스러운 사이트입니다.
CCNP Enterprise 350-401시험응시 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) PDF버전외에 온라인버전과 테스트엔버전 Demo도 다운받아 보실수 있습니다. Omgzlook의 덤프선택으로Cisco 350-401 인증시험인증시험에 응시한다는 것 즉 성공과 멀지 않았습니다. 여러분의 성공을 빕니다.
여러분의 고민도 덜어드릴 수 있습니다. 빨리 성공하고 빨리Cisco 350-401시험응시인증시험을 패스하고 싶으시다면 우리 Omgzlook를 장바구니에 넣으시죠. Omgzlook는 여러분의 아주 좋은 합습가이드가 될것입니다.
어떻게Cisco인증Cisco 350-401시험응시시험을 패스하느냐 에는 여러 가지 방법이 있습니다.
인터넷에는Cisco인증 350-401시험응시시험대비공부자료가 헤아릴수 없을 정도로 많습니다.이렇게 많은Cisco인증 350-401시험응시공부자료중 대부분 분들께서 저희Omgzlook를 선택하는 이유는 덤프 업데이트가 다른 사이트보다 빠르다는 것이 제일 큰 이유가 아닐가 싶습니다. Omgzlook의 Cisco인증 350-401시험응시덤프를 구매하시면 덤프가 업데이트되면 무료로 업데이트된 버전을 제공받을수 있습니다.
그리고 Omgzlook에서는 무료로 24시간 온라인상담이 있습니다. 여러분은 우리.
350-401 PDF DEMO:
QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
Omgzlook의Cisco인증 Juniper JN0-223덤프의 도움으로 Cisco인증 Juniper JN0-223시험을 패스하여 자격증을 취득하면 승진이나 연봉인상의 꿈이 이루어집니다. SAP C_THR81_2405 - Omgzlook 덤프를 사용해보신 분들의 시험성적을 통계한 결과 시험통과율이 거의 100%에 가깝다는 놀라운 결과를 얻었습니다. SAP C_S4FCF_2023 - 사이트에서 데모를 다운받아 보시면 덤프의 일부분 문제를 먼저 풀어보실수 있습니다.구매후 덤프가 업데이트되면 업데이트버전을 무료로 드립니다. Cisco인증Palo Alto Networks PCCSE시험에 도전해보려고 없는 시간도 짜내고 거금을 들여 학원을 선택하셨나요? 사실 IT인증시험은 보다 간단한 공부방식으로 준비하시면 시간도 돈도 정력도 적게 들일수 있습니다. Omgzlook는 고객님께서 첫번째Cisco APICS CSCP시험에서 패스할수 있도록 최선을 다하고 있습니다.
Updated: May 28, 2022