우리 Omgzlook에서는 최고이자 최신의Cisco 인증350-401시험응시료덤프자료를 제공 함으로 여러분을 도와Cisco 인증350-401시험응시료인증자격증을 쉽게 취득할 수 있게 해드립니다.만약 아직도Cisco 인증350-401시험응시료시험패스를 위하여 고군분투하고 있다면 바로 우리 Omgzlook를 선택함으로 여러분의 고민을 날려버릴수 있습니다. Cisco 350-401시험응시료 덤프는 pdf버전,테스트엔진버전, 온라인버전 세가지 버전의 파일로 되어있습니다. pdf버전은 반드시 구매하셔야 하고 테스트엔진버전과 온라인버전은 pdf버전 구매시 추가구매만 가능합니다. Omgzlook의 Cisco 350-401시험응시료 덤프는Cisco 350-401시험응시료시험을 패스하는데 가장 좋은 선택이기도 하고Cisco 350-401시험응시료인증시험을 패스하기 위한 가장 힘이 되어드리는 자료입니다.
CCNP Enterprise 350-401 여러분께서는 아주 순조로이 시험을 패스하실 수 있을 것입니다.
Omgzlook는Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험응시료시험을 패스할 수 있는 아주 좋은 사이트입니다. Omgzlook가 제공하는 시험가이드로 효과적인 학습으로 많은 분들이 모두 인증시험을 패스하였습니다. 이건 모두 Omgzlook 인증시험덤프로 공부하였기 때문입니다.
1년 무료 업데이트서비스를 제공해드리기에 시험시간을 늦추어도 시험성적에 아무런 페를 끼치지 않습니다. Omgzlook에 믿음을 느낄수 있도록 구매사이트마다 무료샘플 다운가능기능을 설치하였습니다.무료샘플을 체험해보시고Omgzlook을 선택해주세요. Omgzlook 에서 출시한Cisco인증350-401시험응시료 덤프는Cisco인증350-401시험응시료 실제시험의 출제범위와 출제유형을 대비하여 제작된 최신버전 덤프입니다.
Cisco 350-401시험응시료 - 만약 시험에서 떨어지셨다고 하면 우리는 무조건 덤프전액 환불을 약속 드립니다.
최근 IT 업종에 종사하는 분들이 점점 늘어가는 추세하에 경쟁이 점점 치열해지고 있습니다. IT인증시험은 국제에서 인정받는 효력있는 자격증을 취득하는 과정으로서 널리 알려져 있습니다. Omgzlook의 Cisco인증 350-401시험응시료덤프는IT인증시험의 한 과목인 Cisco인증 350-401시험응시료시험에 대비하여 만들어진 시험전 공부자료인데 높은 시험적중율과 친근한 가격으로 많은 사랑을 받고 있습니다.
Omgzlook에서 출시한 Cisco 인증350-401시험응시료덤프는 시장에서 가장 최신버전입니다. IT인증자격증은 여느때보다 강렬한 경쟁율을 보이고 있습니다.
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Omgzlook의Cisco인증 CheckPoint 156-521시험덤프 공부가이드는 시장에서 가장 최신버전이자 최고의 품질을 지닌 시험공부자료입니다.IT업계에 종사중이라면 IT자격증취득을 승진이나 연봉협상의 수단으로 간주하고 자격증취득을 공을 들여야 합니다.회사다니면서 공부까지 하려면 몸이 힘들어 스트레스가 많이 쌓인다는것을 헤아려주는Omgzlook가 IT인증자격증에 도전하는데 성공하도록Cisco인증 CheckPoint 156-521시험대비덤프를 제공해드립니다. 그중에서Omgzlook의Cisco SASInstitute A00-215제품이 인지도가 가장 높고 가장 안전하게 시험을 패스하도록 지름길이 되어드릴수 있습니다. Splunk SPLK-5002 - Omgzlook덤프를 구매하시면 많은 정력을 기울이지 않으셔도 시험을 패스하여 자격증취득이 가능합니다. Cisco인증 IBM C1000-138 덤프에 있는 문제만 이해하고 공부하신다면Cisco인증 IBM C1000-138시험을 한방에 패스하여 자격증을 쉽게 취득할수 있을것입니다. Omgzlook의Cisco Network Appliance NS0-528덤프는 모두 영어버전으로 되어있어Cisco Network Appliance NS0-528시험의 가장 최근 기출문제를 분석하여 정답까지 작성해두었기에 문제와 답만 외우시면 시험합격가능합니다.
Updated: May 28, 2022