여러분의 고민도 덜어드릴 수 있습니다. 빨리 성공하고 빨리Cisco 350-401시험유효덤프인증시험을 패스하고 싶으시다면 우리 Omgzlook를 장바구니에 넣으시죠. Omgzlook는 여러분의 아주 좋은 합습가이드가 될것입니다. Omgzlook에서 출시한 Cisco 인증 350-401시험유효덤프시험덤프는Omgzlook의 엘리트한 IT전문가들이 IT인증실제시험문제를 연구하여 제작한 최신버전 덤프입니다. 덤프는 실제시험의 모든 범위를 커버하고 있어 시험통과율이 거의 100%에 달합니다. 우리Omgzlook에서는 끊임없는 업데이트로 항상 최신버전의Cisco인증350-401시험유효덤프시험덤프를 제공하는 사이트입니다, 만약 덤프품질은 알아보고 싶다면 우리Omgzlook 에서 무료로 제공되는 덤프일부분의 문제와 답을 체험하시면 되겠습니다, Omgzlook 는 100%의 보장 도를 자랑하며350-401시험유효덤프시험은 한번에 패스할 수 있는 덤프입니다.
어떻게Cisco인증350-401시험유효덤프시험을 패스하느냐 에는 여러 가지 방법이 있습니다.
인터넷에는Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험유효덤프시험대비공부자료가 헤아릴수 없을 정도로 많습니다.이렇게 많은Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험유효덤프공부자료중 대부분 분들께서 저희Omgzlook를 선택하는 이유는 덤프 업데이트가 다른 사이트보다 빠르다는 것이 제일 큰 이유가 아닐가 싶습니다. 그리고 Omgzlook에서는 무료로 24시간 온라인상담이 있습니다. 여러분은 우리.
Omgzlook의Cisco인증 350-401시험유효덤프덤프의 도움으로 Cisco인증 350-401시험유효덤프시험을 패스하여 자격증을 취득하면 승진이나 연봉인상의 꿈이 이루어집니다. 결코 꿈은 이루어질것입니다. 아무런 노력을 하지 않고 승진이나 연봉인상을 꿈꾸고 있는 분이라면 이 글을 검색해낼수 없었을것입니다.
Cisco 350-401시험유효덤프 - Omgzlook 는 아주 우수한 IT인증자료사이트입니다.
Cisco인증 350-401시험유효덤프시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다. Cisco인증 350-401시험유효덤프인증시험을 패스하여 취득한 자격증은 IT인사로서의 능력을 증명해주며 IT업계에 종사하는 일원으로서의 자존심입니다. Omgzlook 의 Cisco인증 350-401시험유효덤프덤프는 시험패스에 초점을 맞추어 제일 간단한 방법으로 시험을 패스하도록 밀어주는 시험공부가이드입니다.구매전Cisco인증 350-401시험유효덤프무료샘플을 다운받아 적성에 맞는지 확인하고 구매할지 않할지 선택하시면 됩니다.
Omgzlook에는 베터랑의전문가들로 이루어진 연구팀이 잇습니다, 그들은 it지식과 풍부한 경험으로 여러 가지 여러분이Cisco인증350-401시험유효덤프시험을 패스할 수 있을 자료 등을 만들었습니다, Omgzlook 에서는 일년무료 업뎃을 제공하며, Omgzlook 의 덤프들은 모두 높은 정확도를 자랑합니다. Omgzlook 선택함으로 여러분이Cisco인증350-401시험유효덤프시험에 대한 부담은 사라질 것입니다.
350-401 PDF DEMO:
QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
HashiCorp Terraform-Associate-003 - 저희 사이트에서 처음 구매하는 분이라면 덤프풀질에 의문이 갈것입니다. VMware 6V0-32.24 - 망설이지 마십시오. Cisco인증 Microsoft DP-300덤프는Cisco인증 Microsoft DP-300최신 실제시험문제의 모든 시험문제를 커버하고 있어 덤프에 있는 내용만 공부하시면 아무런 걱정없이 시험에 도전할수 있습니다. Omgzlook연구한 전문Cisco Salesforce Public-Sector-Solutions인증시험을 겨냥한 덤프가 아주 많은 인기를 누리고 있습니다. Omgzlook의 전문가들은Cisco Symantec 250-586 최신시험문제를 연구하여 시험대비에 딱 맞는Cisco Symantec 250-586덤프를 출시하였습니다.
Updated: May 28, 2022