Omgzlook의 연구팀에서는Cisco 350-401덤프내용인증덤프만 위하여 지금까지 노력해왔고 Omgzlook 학습가이드Cisco 350-401덤프내용덤프로 시험이 어렵지 않아졌습니다. Omgzlook는 100%한번에Cisco 350-401덤프내용이장시험을 패스할 것을 보장하며 우리가 제공하는 문제와 답을 시험에서 백프로 나올 것입니다.여러분이Cisco 350-401덤프내용시험에 응시하여 우리의 도움을 받는다면 Omgzlook에서는 꼭 완벽한 자료를 드릴 것을 약속합니다. 또한 일년무료 업데이트서비스를 제공합니다.즉 문제와 답이 갱신이 되었을 경우 우리는 여러분들한테 최신버전의 문제와 답을 다시 보내드립니다. Cisco인증350-401덤프내용시험을 패스하기가 어렵다고 하면 합습가이드를 선택하여 간단히 통과하실 수 잇습니다. 우리Omgzlook에서는 무조건 여러분을 위하여 관연 자료덤프 즉 문제와 답을 만들어낼 것입니다. 아니 거이 같습니다.
Cisco 350-401덤프내용인증시험패스에는 많은 방법이 있습니다.
CCNP Enterprise 350-401덤프내용 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlook제공되는 자료는 지식을 장악할 수 있는 반면 많은 경험도 쌓을 수 있습니다. Cisco인증350-401 공부문제시험덤프는Omgzlook가 최고의 선택입니다. 아직도 Cisco인증350-401 공부문제시험준비를 어떻게 해야 할지 망설이고 계시나요? 고객님의 IT인증시험준비길에는 언제나 Omgzlook가 곁을 지켜주고 있습니다.
아직도 Cisco인증350-401덤프내용시험준비를 어떻게 해야 할지 망설이고 계시나요? 고객님의 IT인증시험준비길에는 언제나 Omgzlook가 곁을 지켜주고 있습니다. Omgzlook시험공부자료를 선택하시면 자격증취득의 소원이 이루어집니다. Cisco인증350-401덤프내용시험덤프는Omgzlook가 최고의 선택입니다.
Cisco 350-401덤프내용 - 시간과 돈을 적게 들이는 반면 효과는 십점만점에 십점입니다.
많은 사이트에서 Cisco인증 350-401덤프내용시험대비덤프를 제공해드리는데Omgzlook를 최강 추천합니다. Omgzlook의Cisco인증 350-401덤프내용덤프에는 실제시험문제의 기출문제와 예상문제가 수록되어있어 그 품질 하나 끝내줍니다.적중율 좋고 가격저렴한 고품질 덤프는Omgzlook에 있습니다.
Cisco인증 350-401덤프내용시험을 한방에 편하게 통과하여 자격증을 취득하려면 시험전 공부가이드가 필수입니다. Omgzlook에서 연구제작한 Cisco인증 350-401덤프내용덤프는Cisco인증 350-401덤프내용시험을 패스하는데 가장 좋은 시험준비 공부자료입니다.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
Cisco인증 EMC D-VXR-OE-23덤프는 최근 실제시험문제를 연구하여 제작한 제일 철저한 시험전 공부자료입니다. Omgzlook의Cisco인증 IBM C1000-177덤프로Cisco인증 IBM C1000-177시험공부를 해보세요. Omgzlook의Cisco인증 SAP C-DBADM-2404덤프로 시험을 한방에 통과하여 승진이나 연봉인상에 도움되는 자격증을 취득합시다. 하지만 저희는 수시로 Cisco SAP C_S43_2022 시험문제 변경을 체크하여Cisco SAP C_S43_2022덤프를 가장 최신버전으로 업데이트하도록 최선을 다하고 있습니다. 높은 시험패스율을 자랑하고 있는Cisco인증 Salesforce Sales-Cloud-Consultant덤프는 여러분이 승진으로 향해 달리는 길에 날개를 펼쳐드립니다.자격증을 하루 빨리 취득하여 승진꿈을 이루세요.
Updated: May 28, 2022