만약 시험만 응시하고 싶으시다면 우리의 최신Cisco 200-301학습자료자료로 시험 패스하실 수 있습니다. Omgzlook 의 학습가이드에는Cisco 200-301학습자료인증시험의 예상문제, 시험문제와 답 임으로 100% 시험을 패스할 수 있습니다.우리의Cisco 200-301학습자료시험자료로 충분한 시험준비하시는것이 좋을것 같습니다. 그리고 우리는 일년무료 업데이트를 제공합니다. Omgzlook의 연구팀에서는Cisco 200-301학습자료인증덤프만 위하여 지금까지 노력해왔고 Omgzlook 학습가이드Cisco 200-301학습자료덤프로 시험이 어렵지 않아졌습니다. Omgzlook는 100%한번에Cisco 200-301학습자료이장시험을 패스할 것을 보장하며 우리가 제공하는 문제와 답을 시험에서 백프로 나올 것입니다.여러분이Cisco 200-301학습자료시험에 응시하여 우리의 도움을 받는다면 Omgzlook에서는 꼭 완벽한 자료를 드릴 것을 약속합니다. Cisco인증200-301학습자료시험을 패스하기가 어렵다고 하면 합습가이드를 선택하여 간단히 통과하실 수 잇습니다.
CCNA 200-301 아니 거이 같습니다.
Cisco 200-301 - Cisco Certified Network Associate Exam학습자료인증시험패스에는 많은 방법이 있습니다. 비록Cisco 200-301 Dumps인증시험은 어렵지만 우리Omgzlook의 문제집으로 가이드 하면 여러분은 아주 자신만만하게 응시하실 수 있습니다. 안심하시고 우리 Omgzlook가 제공하는 알맞춤 문제집을 사용하시고 완벽한Cisco 200-301 Dumps인증시험 준비를 하세요.
아직도 Cisco인증200-301학습자료시험준비를 어떻게 해야 할지 망설이고 계시나요? 고객님의 IT인증시험준비길에는 언제나 Omgzlook가 곁을 지켜주고 있습니다. Omgzlook시험공부자료를 선택하시면 자격증취득의 소원이 이루어집니다. Cisco인증200-301학습자료시험덤프는Omgzlook가 최고의 선택입니다.
Cisco 200-301학습자료 - 시간과 돈을 적게 들이는 반면 효과는 십점만점에 십점입니다.
많은 사이트에서 Cisco인증 200-301학습자료시험대비덤프를 제공해드리는데Omgzlook를 최강 추천합니다. Omgzlook의Cisco인증 200-301학습자료덤프에는 실제시험문제의 기출문제와 예상문제가 수록되어있어 그 품질 하나 끝내줍니다.적중율 좋고 가격저렴한 고품질 덤프는Omgzlook에 있습니다.
Cisco인증 200-301학습자료시험을 한방에 편하게 통과하여 자격증을 취득하려면 시험전 공부가이드가 필수입니다. Omgzlook에서 연구제작한 Cisco인증 200-301학습자료덤프는Cisco인증 200-301학습자료시험을 패스하는데 가장 좋은 시험준비 공부자료입니다.
200-301 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 2
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
Cisco인증 Snowflake ARA-C01덤프는 최근 실제시험문제를 연구하여 제작한 제일 철저한 시험전 공부자료입니다. Omgzlook의Cisco인증 Amazon SOA-C02-KR덤프로Cisco인증 Amazon SOA-C02-KR시험공부를 해보세요. SASInstitute A00-215 - Omgzlook제품은 100%통과율을 자랑하고 있습니다. 하지만 저희는 수시로 Cisco Salesforce Heroku-Architect 시험문제 변경을 체크하여Cisco Salesforce Heroku-Architect덤프를 가장 최신버전으로 업데이트하도록 최선을 다하고 있습니다. 높은 시험패스율을 자랑하고 있는Cisco인증 SAP C_THR81_2405덤프는 여러분이 승진으로 향해 달리는 길에 날개를 펼쳐드립니다.자격증을 하루 빨리 취득하여 승진꿈을 이루세요.
Updated: May 28, 2022