It is common in modern society that many people who are more knowledgeable and capable than others finally lost some good opportunities for development because they didn’t obtain the 350-401 Practice Exam Online certification. The prerequisite for obtaining the 350-401 Practice Exam Online certification is to pass the exam, but not everyone has the ability to pass it at one time. But our 350-401 Practice Exam Online exam questions will help you pass the exam by just one go for we have the pass rate high as 98% to 100%. We provide free tryout before the purchase to let you decide whether it is valuable or not by yourself. To further understand the merits and features of our 350-401 Practice Exam Online practice engine you could look at the introduction of our product in detail. They must grasp every minute and every second to prepare for it.
CCNP Enterprise 350-401 But they do not know which to believe.
Omgzlook can not only provide all the information related to the Cisco certification 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Practice Exam Online exam for the candidates, but also provide a good learning opportunity for them. This is indeed true, no doubt, do not consider, act now. In this era, everything is on the rise.
With Omgzlook's help, you do not need to spend a lot of money to participate in related cram or spend a lot of time and effort to review the relevant knowledge, but can easily pass the exam. Simulation test software of Cisco 350-401 Practice Exam Online exam is developed by Omgzlook's research of previous real exams. Omgzlook's Cisco 350-401 Practice Exam Online exam practice questions have a lot of similarities with the real exam practice questions.
Cisco 350-401 Practice Exam Online - You can experience it in advance.
In order to meet the request of current real test, the technology team of research on Omgzlook Cisco 350-401 Practice Exam Online exam materials is always update the questions and answers in time. We always accept feedbacks from users, and take many of the good recommendations, resulting in a perfect Omgzlook Cisco 350-401 Practice Exam Online exam materials. This allows Omgzlook to always have the materials of highest quality.
Once you have checked our demo, you will find the study materials we provide are what you want most. Our target is to reduce your pressure and improve your learning efficiency from preparing for 350-401 Practice Exam Online exam.
350-401 PDF DEMO:
QUESTION NO: 1
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 2
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 3
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
Linux Foundation FOCP - In this competitive world, it is more important than ever. Have you ever tried our IT exam certification software provided by our Omgzlook? If you have, you will use our APICS CSCP exam software with no doubt. SAP P-SAPEA-2023 - Our strength will make you incredible. ISTQB CT-AI - We try our best to ensure 100% pass rate for you. Cisco 500-490 - The opportunity always belongs to a person who has the preparation.
Updated: May 28, 2022