Using our 350-401 Latest Test Pattern study braindumps, you will find you can learn about the knowledge of your exam in a short time. Because you just need to spend twenty to thirty hours on the practice exam, our 350-401 Latest Test Pattern study materials will help you learn about all knowledge, you will successfully pass the 350-401 Latest Test Pattern exam and get your certificate. So if you think time is very important for you, please try to use our 350-401 Latest Test Pattern study materials, it will help you save your time. Our 350-401 Latest Test Pattern materials provide you with the best learning prospects and give you more than you expect by adopting minimal effort. Perhaps the path to successful pass the 350-401 Latest Test Pattern is filled variables, but now there is only one possibility to successfully obtain a 350-401 Latest Test Pattern certification. The combination of 350-401 Latest Test Pattern Exam practice software and PDF Questions and Answers make the preparation easier and increase the chances to get higher score in the 350-401 Latest Test Pattern exam.
CCNP Enterprise 350-401 Also, they have respect advantages.
Come and buy our 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Latest Test Pattern exam questions! However, how to pass Cisco certification Exam 350-401 Bible exam quickly and simply? Our Omgzlook can always help you solve this problem quickly. In Omgzlook we provide the Exam 350-401 Bible certification exam training tools to help you pass the exam successfully.
And after using our 350-401 Latest Test Pattern learning prep, they all have marked change in personal capacity to deal with the 350-401 Latest Test Pattern exam intellectually. The world is full of chicanery, but we are honest and professional in this area over ten years. Even if you are newbie, it does not matter as well.
Cisco 350-401 Latest Test Pattern - A bad situation can show special integrity.
With the help of our 350-401 Latest Test Pattern study guide, you can adjust yourself to the exam speed and stay alert according to the time-keeper that we set on our 350-401 Latest Test Pattern training materials. Therefore, you can trust on our 350-401 Latest Test Pattern exam materials for this effective simulation function will eventually improve your efficiency and assist you to succeed in the 350-401 Latest Test Pattern exam. And we believe you will pass the 350-401 Latest Test Pattern exam just like the other people!
If you want to pass the Cisco 350-401 Latest Test Pattern exam, you'd better to buy Omgzlook's exam training materials quickly. How far the distance between words and deeds? It depends to every person.
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
So choosing our SAP C-S4TM-2023 training materials is a wise choice. It is inconceivable that Omgzlook Cisco HP HPE0-V27-KR test dumps have 100% hit rate. Considering your practical constraint and academic requirements of the NetSuite SuiteFoundation exam preparation, you may choose the NetSuite SuiteFoundation practice materials with following traits. Microsoft PL-400-KR - In addition, if you first take the exam, you can use software version dumps. Fortinet NSE7_OTS-7.2 - Then you can learn and practice it.
Updated: May 28, 2022