They have always been in a trend of advancement. Admittedly, our 200-301 Test Simulator Online real questions are your best choice. We also estimate the following trend of exam questions may appear in the next exam according to syllabus. So our 200-301 Test Simulator Online test prep will not occupy too much time. You might think that it is impossible to memorize well all knowledge. As long as you practice our 200-301 Test Simulator Online test question, you can pass exam quickly and successfully.
200-301 Test Simulator Online exam prep look forward to meeting you.
CCNA 200-301 Test Simulator Online - Cisco Certified Network Associate Exam Our ability of improvement is stronger than others. Using 200-301 Related Content exam prep is an important step for you to improve your soft power. I hope that you can spend a little time understanding what our study materials have to attract customers compared to other products in the industry.
Also, you must open the online engine of the study materials in a network environment for the first time. In addition, the 200-301 Test Simulator Online study dumps don’t occupy the memory of your computer. When the online engine is running, it just needs to occupy little running memory.
Cisco 200-301 Test Simulator Online - I wish you good luck.
Omgzlook website is fully equipped with resources and the questions of Cisco 200-301 Test Simulator Online exam, it also includes the Cisco 200-301 Test Simulator Online exam practice test. Which can help candidates prepare for the exam and pass the exam. You can download the part of the trial exam questions and answers as a try. Omgzlook provide true and comprehensive exam questions and answers. With our exclusive online Cisco 200-301 Test Simulator Online exam training materials, you'll easily through Cisco 200-301 Test Simulator Online exam. Our site ensure 100% pass rate.
If you use Omgzlook'straining program, you can 100% pass the exam. If you fail the exam, we will give a full refund to you.
200-301 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
QUESTION NO: 2
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
QUESTION NO: 3
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 4
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 5
Which network allows devices to communicate without the need to access the Internet?
A. 209.165.201.0/24
B. 192.0.0.0/8
C. 172.28.0.0/16
D. 1729.0.0/16
Answer: C
Explanation:
This question asks about the private ranges of IPv4 addresses. The private ranges of each class of IPv4 are listed below:
Class A private IP address ranges from 10.0.0.0 to 10.255.255.255 Class B private IP address ranges from 172.16.0.0 to 172.31.255.255 Class C private IP address ranges from 192.168.0.0 to
192.168.255.255 Only the network 172.28.0.0/16 belongs to the private IP address (of class B).
There are many dumps and training materials providers that would guarantee you pass the Cisco Huawei H23-211_V1.0 exam. So IT professionals to enhance their knowledge through Cisco American College of Rheumatology RhMSUS exam certification. Cisco Microsoft AZ-400 certification exam will definitely lead you to a better career prospects. Omgzlook Cisco CompTIA SY0-701 exam training materials bear with a large number of the exam questions you need, which is a good choice. Adobe AD0-E121 - Select it will be your best choice.
Updated: May 28, 2022