Moreover, we have experts to update 350-401 Exam Syllabus quiz torrent in terms of theories and contents according to the changeable world on a daily basis, which can ensure that you are not falling behind of others by some slight knowledge gaps. Are you still worried about the exam? Don’t worry! Our 350-401 Exam Syllabus exam torrent can help you overcome this stumbling block during your working or learning process. So, as long as you make use of our dumps, 350-401 Exam Syllabus certificate exam will not a problem. Are you bothered by looking for good exam materials of Cisco 350-401 Exam Syllabus test? Don't worry. So many our customers have benefited form our 350-401 Exam Syllabus preparation quiz, so will you!
CCNP Enterprise 350-401 We believe that you will like our products.
As we will find that, get the test 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Exam Syllabus certification, acquire the qualification of as much as possible to our employment effect is significant. In the process of using the Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) study question, if the user has some problems, the IT professor will 24 hours online to help users solve, the user can send email or contact us on the online platform. Of course, a lot of problems such as soft test engine appeared some faults or abnormal stating run phenomenon of our Valid Test 350-401 Experience exam question, these problems cannot be addressed by simple language, we will service a secure remote assistance for users and help users immediate effectively solve the existing problems of our Valid Test 350-401 Experience torrent prep, thus greatly enhance the user experience, beneficial to protect the user's learning resources and use digital tools, let users in a safe and healthy environment to study Valid Test 350-401 Experience exam question.
Our goal is to increase customer's satisfaction and always put customers in the first place. As for us, the customer is God. We provide you with 24-hour online service for our 350-401 Exam Syllabus study tool.
Cisco 350-401 Exam Syllabus - They are free demos.
On the one hand, our company hired the top experts in each qualification examination field to write the 350-401 Exam Syllabus prepare dump, so as to ensure that our products have a very high quality, so that users can rest assured that the use of our research materials. On the other hand, under the guidance of high quality research materials, the rate of adoption of the 350-401 Exam Syllabus exam guide is up to 98% to 100%. Of course, it is necessary to qualify for a qualifying exam, but more importantly, you will have more opportunities to get promoted in the workplace.
When we choose the employment work, you will meet a bottleneck, how to let a company to choose you to be a part of him? We would say ability, so how does that show up? There seems to be only one quantifiable standard to help us get a more competitive job, which is to get the test 350-401 Exam Syllabuscertification and obtain a qualification. If you want to have a good employment platform, then take office at the same time there is a great place to find that we have to pay attention to the importance of qualification examination.
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Huawei H12-631_V1.0 - You will get a better job or get a big rise on the position as well as the salary. Nutanix NCP-DB - For years our team has built a top-ranking brand with mighty and main which bears a high reputation both at home and abroad. SAP C-C4H620-34 practice prep broke the limitations of devices and networks. EMC D-ISM-FN-23 - It absolutely has no problem. Watch carefully you will find that more and more people are willing to invest time and energy on the Huawei H13-611_V5.0 exam, because the exam is not achieved overnight, so many people are trying to find a suitable way.
Updated: May 28, 2022