Believe us because the 350-401 Exam Dumps.Zip test prep are the most useful and efficient, and the 350-401 Exam Dumps.Zip exam preparation will make you master the important information and the focus of the exam. We are sincerely hoping to help you pass the exam. You can learn our 350-401 Exam Dumps.Zip test prep in the laptops or your cellphone and study easily and pleasantly as we have different types, or you can print our PDF version to prepare your exam which can be printed into papers and is convenient to make notes. Your selection on the riht tool to help your pass the 350-401 Exam Dumps.Zip exam and get the according certification matters a lot for the right 350-401 Exam Dumps.Zip exam braindumps will spread you a lot of time and efforts. Our 350-401 Exam Dumps.Zip study guide is the most reliable and popular exam product in the marcket for we only sell the latest 350-401 Exam Dumps.Zip practice engine to our clients and you can have a free trial before your purchase. As is known to all, 350-401 Exam Dumps.Zip practice guide simulation plays an important part in the success of exams.
CCNP Enterprise 350-401 It is your right time to make your mark.
Secondly, since our 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Exam Dumps.Zip training quiz appeared on the market, seldom do we have the cases of customer information disclosure. Everyone's life course is irrevocable, so missing the opportunity of this time will be a pity. During the prolonged review, many exam candidates feel wondering attention is hard to focus.
The questions of our 350-401 Exam Dumps.Zip guide questions are related to the latest and basic knowledge. What’s more, our 350-401 Exam Dumps.Zip learning materials are committed to grasp the most knowledgeable points with the fewest problems. So 20-30 hours of study is enough for you to deal with the exam.
Cisco 350-401 Exam Dumps.Zip - As the saying goes, Rome is not build in a day.
In order to facilitate the wide variety of users' needs the 350-401 Exam Dumps.Zip study guide have developed three models with the highest application rate in the present - PDF, software and online. No matter you are a student, a office staff or even a housewife, you can always find your most situable way to study our 350-401 Exam Dumps.Zip exam Q&A. Generally speaking, these three versions of our 350-401 Exam Dumps.Zip learning guide can support study on paper, computer and all kinds of eletronic devices. They are quite convenient.
The 350-401 Exam Dumps.Zip latest dumps will be a shortcut for a lot of people who desire to be the social elite. If you try your best to prepare for the 350-401 Exam Dumps.Zip exam and get the related certification in a short time, it will be easier for you to receive the attention from many leaders of the big company, and it also will be very easy for many people to get a decent job in the labor market by the 350-401 Exam Dumps.Zip learning guide.
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Our SAP P_SAPEA_2023 learning materials provide you with a platform of knowledge to help you achieve your wishes. According to the survey of our company, we have known that a lot of people hope to try the F5 302 test training materials from our company before they buy the study materials, because if they do not have a try about our study materials, they cannot sure whether the study materials from our company is suitable for them to prepare for the exam or not. In 21st century, every country had entered the period of talent competition, therefore, we must begin to extend our GAQM CSCM-001 personal skills, only by this can we become the pioneer among our competitors. All the experts in our company are devoting all of their time to design the best ISQI CTAL-TTA_Syll19_4.0test question for all people. What is more, our Cisco 300-415 practice engine persists in creating a modern service oriented system and strive for providing more preferential activities for your convenience.
Updated: May 28, 2022