また、OmgzlookのCiscoの350-401 Pdf問題サンプル試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。OmgzlookのCiscoの350-401 Pdf問題サンプル試験トレーニング資料を利用したらきっと成功できますから、Omgzlookを選ばない理由はないです。試験の準備をするためにOmgzlookのCiscoの350-401 Pdf問題サンプル試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。 これは多くの受験生に証明された事実です。Ciscoの350-401 Pdf問題サンプル認定試験を受験するあなたは、試験に合格する自信を持たないですか。 IT認定試験の中でどんな試験を受けても、Omgzlookの350-401 Pdf問題サンプル試験参考資料はあなたに大きなヘルプを与えることができます。
その中で、350-401 Pdf問題サンプル認定試験は最も重要な一つです。
君は一回だけでCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Pdf問題サンプル認定試験に合格したいなら、或いは自分のIT技能を増強したいなら、Omgzlookはあなたにとって最高な選択です。 早速買いに行きましょう。OmgzlookのCiscoの350-401 復習対策試験トレーニング資料を使ったら、君のCiscoの350-401 復習対策認定試験に合格するという夢が叶えます。
OmgzlookのCiscoの350-401 Pdf問題サンプル試験トレーニング資料を利用すれば、認定試験に合格するのは簡単になります。うちのCiscoの350-401 Pdf問題サンプル試験トレーニング資料は豊富な経験を持っている専門家が長年の研究を通じて開発されたものです。Omgzlookの学習教材は君の初めての試しでCiscoの350-401 Pdf問題サンプル認定試験に合格するのに助けます。
Cisco 350-401 Pdf問題サンプル - それは正確性が高くて、カバー率も広いです。
あなたはCiscoの350-401 Pdf問題サンプル試験への努力を通して満足的な結果を得られているのは我々Omgzlookの希望です。信じられないなら、弊社のデモをやってみて、Ciscoの350-401 Pdf問題サンプル試験問題集を体験することができます。試して我々専門家たちの真面目さを感じられています。Ciscoの350-401 Pdf問題サンプル試験のほかの試験に参加するつもりでしたら、あなたも弊社のOmgzlookでふさわしいソフトを探すことができます。あなたは満足できると信じています。
もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの350-401 Pdf問題サンプル試験のソフトウェアです。我々はあなたに提供するのは最新で一番全面的なCiscoの350-401 Pdf問題サンプル問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401 Pdf問題サンプル試験のソフトウェアの更新です。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
我々はあなたに提供するのは最新で一番全面的なCiscoのSalesforce B2C-Commerce-Architect問題集で、最も安全な購入保障で、最もタイムリーなCiscoのSalesforce B2C-Commerce-Architect試験のソフトウェアの更新です。 CiscoのHP HP2-I60の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのHP HP2-I60試験に一番信頼できるヘルプを提供します。 我々Omgzlookの研究したCiscoのSalesforce Marketing-Cloud-Developerの復習資料は科学的な方法であなたの圧力を減少します。 IIA IIA-CIA-Part1-JPN - 社会と経済の発展につれて、多くの人はIT技術を勉強します。 IIA IIA-CHAL-QISA - 準備の段階であなたはリーダーしています。
Updated: May 28, 2022