短い時間に最も小さな努力で一番効果的にCiscoの350-401難易度試験の準備をしたいのなら、OmgzlookのCiscoの350-401難易度試験トレーニング資料を利用することができます。Omgzlookのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。Omgzlookを利用したら、あなたは自分の目標を達成することができ、最良の結果を得ます。 自分の幸せは自分で作るものだと思われます。ただ、社会に入るIT卒業生たちは自分能力の不足で、350-401難易度試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの350-401難易度練習問題を選んで実用能力を速く高め、自分を充実させます。 Omgzlookトレーニング資料を選んだら、あなたは自分の夢を実現できます。
CCNP Enterprise 350-401 あなたは最高の方法を探しましたから。
インターネットで時勢に遅れない350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)難易度勉強資料を提供するというサイトがあるかもしれませんが、Omgzlookはあなたに高品質かつ最新のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)難易度トレーニング資料を提供するユニークなサイトです。 試験を怖く感じるのはかなり正常です。特にCiscoの350-401 ダウンロードのような難しい試験です。
Omgzlookが提供したCiscoの350-401難易度トレーニング資料を利用したら、Ciscoの350-401難易度認定試験に受かることはたやすくなります。Omgzlookがデザインしたトレーニングツールはあなたが一回で試験に合格することにヘルプを差し上げられます。OmgzlookのCiscoの350-401難易度トレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。
その中で、Cisco 350-401難易度認定試験は最も重要な一つです。
350-401難易度試験に合格するために、どうすればいいですか？たくさんの人はそのような疑問があるかましれません。最もよい方法は350-401難易度問題集を買うことです。350-401難易度問題集の合格率は高いです。また、弊社はいいサービスを提供します。350-401難易度問題集の更新版があったら、すぐお客様のメールボックスに送付します。どんな質問があっても、すぐ返事できます。だから、350-401難易度試験に合格するには、350-401難易度問題集を買うことは最善の選択です。
なぜなら、それはCiscoの350-401難易度認定試験に関する必要なものを含まれるからです。Omgzlookを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
そして、あなたはSAP C-S43-2023復習教材の三種類のデモをダウンロードできます。 OmgzlookのCiscoのSAP C_TS462_2023試験トレーニング資料はCiscoのSAP C_TS462_2023認定試験を準備するのリーダーです。 EMC D-PSC-DS-23 - 貴方達の試験に合格させることができないと、すぐに全額で返金いたします。 もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoのISC CISSP-JP試験のソフトウェアです。 Omgzlookが提供したCiscoのFortinet NSE7_SDW-7.2-JPN試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、100%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。
Updated: May 28, 2022