350-401関連資格知識 & 350-401受験対策解説集 - Cisco 350-401模擬対策 - Omgzlook

OmgzlookはCiscoの350-401関連資格知識認定試験に便利なサービスを提供するサイトで、従来の試験によってOmgzlook が今年のCiscoの350-401関連資格知識認定試験を予測してもっとも真実に近い問題集を研究し続けます。 あなたは350-401関連資格知識試験に不安を持っていますか?350-401関連資格知識参考資料をご覧下さい。私たちの350-401関連資格知識参考資料は十年以上にわたり、専門家が何度も練習して、作られました。 Ciscoの350-401関連資格知識認定試験に準備する練習ツールや訓練機関に通学しなればまりませんでしょう。

CCNP Enterprise 350-401 弊社の商品が好きなのは弊社のたのしいです。

CCNP Enterprise 350-401関連資格知識 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookを選択したら、成功が遠くではありません。 Omgzlook を選択して100%の合格率を確保することができて、もし試験に失敗したら、Omgzlookが全額で返金いたします。

あなたに予想外の良い効果を見せられますから。350-401関連資格知識認定試験についてのことですが、Omgzlookは素晴らしい資質を持っていて、最も信頼できるソースになることができます。何千何万の登録された部門のフィードバックによって、それに大量な突っ込んだ分析を通じて、我々はどのサプライヤーがお客様にもっと新しいかつ高品質の350-401関連資格知識資料を提供できるかを確かめる存在です。

Cisco 350-401関連資格知識 - Omgzlookには専門的なエリート団体があります。

Omgzlookは高品質の製品を提供するだけではなく、完全なアフターサービスも提供します。当社の製品を利用したら、一年間の無料更新サービスを提供します。しかも、速いスピードで受験生の皆様に提供して差し上げます。あなたがいつでも最新の試験資料を持っていることを保証します。

試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。あなたのニーズをよく知っていていますから、あなたに試験に合格する自信を与えます。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

Palo Alto Networks PCNSE-JPN - 順調にIT認定試験に合格したいなら、Omgzlookはあなたの唯一の選択です。 EMC D-CS-DS-23 - Omgzlookを選んだら、成功への扉を開きます。 では、なぜ他の人が簡単にCisco 300-815試験に合格することができるかを知りたいですか。 Apple Apple-Device-Support-JPN - このような素晴らしい資料をぜひ見逃さないでください。 それはもちろんOmgzlookのAdobe AD0-E716問題集ですよ。

Updated: May 28, 2022