現在IT技術会社に通勤しているあなたは、Ciscoの350-401資格認証攻略試験認定を取得しましたか？350-401資格認証攻略試験認定は給料の増加とジョブのプロモーションに役立ちます。短時間で350-401資格認証攻略試験に一発合格したいなら、我々社のCiscoの350-401資格認証攻略資料を参考しましょう。また、350-401資格認証攻略問題集に疑問があると、メールで問い合わせてください。 我々が今行っている保証は私たちが信じられないほどのフォームです。Ciscoの350-401資格認証攻略試験はOmgzlookの保証を検証することができ、１００パーセントの合格率に達することができます。 だから、我々社は力の限りで弊社のCisco 350-401資格認証攻略試験資料を改善し、改革の変更に応じて更新します。
CCNP Enterprise 350-401 これは受験生の皆様を助けた結果です。
あなたは350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認証攻略試験に不安を持っていますか？350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認証攻略参考資料をご覧下さい。 Ciscoの350-401 学習教材試験に受かるのはあなたが自分をIT業種にアピールする方法の一つです。でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、OmgzlookのCiscoの350-401 学習教材試験トレーニング資料を選んだらいいです。
Omgzlookはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。Omgzlookは専門のIT業界での評判が高くて、あなたがインターネットでOmgzlookの部分のCisco 350-401資格認証攻略「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」資料を無料でダウンロードして、弊社の正確率を確認してください。弊社の商品が好きなのは弊社のたのしいです。
Cisco 350-401資格認証攻略 - そうだったら、Omgzlookを利用したください。
Omgzlook を選択して１００％の合格率を確保することができて、もし試験に失敗したら、Omgzlookが全額で返金いたします。
OmgzlookのCiscoの350-401資格認証攻略試験トレーニング資料はあなたの成功への第一歩です。この資料を持っていたら、難しいCiscoの350-401資格認証攻略認定試験に合格することができるようになります。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
EMC D-SF-A-24 - そうしたらあなたはOmgzlookが用意した問題集にもっと自信があります。 OmgzlookのEMC D-PM-MN-23問題集を入手してから、非常に短い時間で試験に準備しても、あなたは順調に試験に合格することができます。 OmgzlookにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco EMC D-PE-FN-23認証試験に参加する方に対して問題集を研究続けています。 それはOmgzlookのMicrosoft DP-300-KR問題集です。 EMC D-PSC-MN-01 - もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。
Updated: May 28, 2022