この目標を実現するようには、我が社のOmgzlookは試験改革のとともにめざましく推進していき、最も専門的な350-401資格認定試験問題集をリリースしています。現時点で我々のCisco 350-401資格認定試験問題集を使用しているあなたは試験にうまくパースできると信じられます。心配なく我々の真題を利用してください。 すべてのことの目的はあなたに安心に試験に準備さされるということです。弊社のOmgzlookはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoの350-401資格認定試験試験問題集を提供いたします。 Omgzlookの350-401資格認定試験問題集を購入し勉強するだけ、あなたは試験にたやすく合格できます。
CCNP Enterprise 350-401 では、試験を心配するより、今から行動しましょう。
我々OmgzlookはCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認定試験試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 PC版は、実際の試験環境を模擬し、Windowsシステムのコンピュータに適します。350-401 試験復習試験資料の3つのバージョンのなかで、PDFバージョンの350-401 試験復習トレーニングガイドは、ダウンロードと印刷でき、受験者のために特に用意されています。
競争力が激しい社会に当たり、我々Omgzlookは多くの受験生の中で大人気があるのは受験生の立場からCisco 350-401資格認定試験試験資料をリリースすることです。たとえば、ベストセラーのCisco 350-401資格認定試験問題集は過去のデータを分析して作成ます。ほんとんどお客様は我々OmgzlookのCisco 350-401資格認定試験問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。
Cisco 350-401資格認定試験認定試験に合格することは難しいようですね。
長年にわたり、OmgzlookはずっとIT認定試験を受験する皆さんに最良かつ最も信頼できる参考資料を提供するために取り組んでいます。IT認定試験の出題範囲に対して、Omgzlookは豊富な経験を持っています。また、Omgzlookは数え切れない受験生を助け、皆さんの信頼と称賛を得ました。ですから、Omgzlookの350-401資格認定試験問題集の品質を疑わないでください。これは間違いなくあなたが350-401資格認定試験認定試験に合格することを保証できる問題集です。Omgzlookは試験に失敗すれば全額返金を保証します。このような保証があれば、Omgzlookの350-401資格認定試験問題集を購入しようか購入するまいかと躊躇する必要は全くないです。この問題集をミスすればあなたの大きな損失ですよ。
Omgzlookは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。
350-401 PDF DEMO:
QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B
QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html
QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Microsoft MS-900 - この問題集は絶対あなたがずっと探しているものです。 OmgzlookのCiscoのSalesforce Salesforce-AI-Specialist試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 SAP C_TS412_2021-JPN - 自分のスキルを向上させ、よりよく他の人に自分の能力を証明したいですか。 IBM C1000-183 - 我々の誠意を信じてください。 それは現在、市場上でCisco のSAP C-THR92-2405認定試験に合格する率が一番高いからです。
Updated: May 28, 2022