この問題集をミスすればあなたの大きな損失ですよ。長年にわたり、OmgzlookはずっとIT認定試験を受験する皆さんに最良かつ最も信頼できる参考資料を提供するために取り組んでいます。IT認定試験の出題範囲に対して、Omgzlookは豊富な経験を持っています。 ここには、私たちは君の需要に応じます。OmgzlookのCiscoの350-401資格模擬問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。 この資料を使用すると、あなたの学習効率を向上させ、多くの時間を節約することができます。
全力を尽くせば、350-401資格模擬試験の合格も可能となります。
CCNP Enterprise 350-401資格模擬 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 弊社の商品が好きなのは弊社のたのしいです。 このほど、今のIT会社は多くのIT技術人材を急速に需要して、あなたはこのラッキーな人になりたいですか？Ciscoの350-401 対応受験試験に参加するのはあなたに自身のレベルを高めさせるだけでなく、あなたがより良く就職し輝かしい未来を持っています。弊社OmgzlookはCiscoの350-401 対応受験問題集を購入し勉強した後、あなたは350-401 対応受験試験に合格することでできると信じています。
Omgzlook を選択して１００％の合格率を確保することができて、もし試験に失敗したら、Omgzlookが全額で返金いたします。
Cisco 350-401資格模擬 - Omgzlookを選んだら、成功への扉を開きます。
350-401資格模擬認定試験は専門知識と情報技術を検査する試験で、Omgzlookが一日早くCiscoの350-401資格模擬認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」に合格させるのサイトで試験の前に弊社が提供する訓練練習問題をテストして、短い時間であなたの収穫が大きいです。
このような素晴らしい資料をぜひ見逃さないでください。IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
Adobe AD0-E903 - 試験に合格するのは簡単ではないもよくわかりましょう。 あるいは、無料で試験SAP C_HRHPC_2405問題集を更新してあげるのを選択することもできます。 Microsoft AZ-204J - そうしたら、完全な試験準備をして、気楽に試験を受かることができるようになります。 ACAMS CAMS - なぜ受験生のほとんどはOmgzlookを選んだのですか。 Omgzlook はあなたに最新の試験研究資料を提供しますから、Omgzlook CiscoのHP HPE0-V26問題集を持っていたら、試験に直面する自信に満ちることができ、合格しないなんて全然心配することはなく気楽に試験に受かることができます。
Updated: May 28, 2022