Ciscoの認証資格は最近ますます人気になっていますね。国際的に認可された資格として、Ciscoの認定試験を受ける人も多くなっています。その中で、350-401資格問題集認定試験は最も重要な一つです。 そうしたらあなたはOmgzlookが用意した問題集にもっと自信があります。早くOmgzlookの問題集を君の手に入れましょう。 Omgzlookを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。
CCNP Enterprise 350-401 それは正確性が高くて、カバー率も広いです。
CCNP Enterprise 350-401資格問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) それを利用したら、初めに試験を受けても、合格する自信を持つようになります。 我々はあなたに提供するのは最新で一番全面的なCiscoの350-401 テスト模擬問題集問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401 テスト模擬問題集試験のソフトウェアの更新です。無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの350-401 テスト模擬問題集試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。
OmgzlookはIT領域の10年以上の認定経験を持っていますから、問題と解答に含まれています。350-401資格問題集試験に準備するためにインターネットで色々なトレーニングツールを見つけることができますが、Omgzlook の350-401資格問題集試験資料は最も良いトレーニング資料です。、弊社は最全面的な認証試験問題と解答を提供するだけでまく、一年間の無料更新サービスも提供いたします。
Cisco 350-401資格問題集 - 私の夢は最高のIT専門家になることです。
あなたは今Ciscoの350-401資格問題集試験のために準備していますか。そうであれば、あなたは夢がある人だと思います。我々Omgzlookはあなたのような人に夢を叶えさせるという目標を持っています。我々の開発するCiscoの350-401資格問題集ソフトは最新で最も豊富な問題集を含めています。あなたは我々の商品を購入したら、一年間の無料更新サービスを得られています。我々のソフトを利用してCiscoの350-401資格問題集試験に合格するのは全然問題ないです。
きっと望んでいるでしょう。では、常に自分自身をアップグレードする必要があります。
350-401 PDF DEMO:
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
我々OmgzlookのITエリートと我々のCiscoのJuniper JN0-280試験のソフトに満足するお客様は我々に自信を持たせます。 OmgzlookのMicrosoft AZ-140教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。 Microsoft AI-900J - 購入したい意向があれば、我々Omgzlookのホームページをご覧になってください。 Fortinet FCP_FGT_AD-7.4 - Omgzlookの問題集を利用することは正にその最良の方法です。 試験に合格したお客様は「HP HPE6-A73問題集のオンライン版を利用して、模擬試験を繰り返して受けました。
Updated: May 28, 2022