我々OmgzlookはCiscoの350-401資格問題対応試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401資格問題対応試験問題集を開発するのに準備します。 Omgzlookを利用したら、試験に合格しないことは絶対ないです。OmgzlookのCiscoの350-401資格問題対応試験トレーニング資料はあなたに時間とエネルギーを節約させます。 競争力が激しい社会に当たり、我々Omgzlookは多くの受験生の中で大人気があるのは受験生の立場からCisco 350-401資格問題対応試験資料をリリースすることです。
それはOmgzlookの350-401資格問題対応問題集です。
弊社Omgzlookの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格問題対応試験問題集を介して、速く試験に合格して350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格問題対応試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。 ここには、私たちは君の需要に応じます。OmgzlookのCiscoの350-401 テスト資料問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。
弊社のCisco 350-401資格問題対応問題集を使用した後、350-401資格問題対応試験に合格するのはあまりに難しくないことだと知られます。我々Omgzlook提供する350-401資格問題対応問題集を通して、試験に迅速的にパースする技をファンドできます。あなたのご遠慮なく購買するために、弊社は提供する無料のCisco 350-401資格問題対応問題集デーモをダウンロードします。
Cisco 350-401資格問題対応 - 我々の誠意を信じてください。
現在の社会で、350-401資格問題対応試験に参加する人がますます多くなる傾向があります。市場の巨大な練習材料から350-401資格問題対応の学習教材を手に入れようとする人も増えています。 私たちの350-401資格問題対応試験問題を利用し、ほかの資料が克服できない障害を克服できます。 多くの受験者は、私たちの350-401資格問題対応練習試験をすることに特権を感じています。 そして、私たちのウェブサイトは、市場でのとても有名で、インターネット上で簡単に見つけられます。
自分のIT業界での発展を希望したら、Ciscoの350-401資格問題対応試験に合格する必要があります。Ciscoの350-401資格問題対応試験はいくつ難しくても文句を言わないで、我々Omgzlookの提供する資料を通して、あなたはCiscoの350-401資格問題対応試験に合格することができます。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
Salesforce Public-Sector-Solutions - OmgzlookはきみのIT夢に向かって力になりますよ。 ISM LEAD - 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。 EMC D-MN-OE-23 - 今の多士済々な社会の中で、IT専門人士はとても人気がありますが、競争も大きいです。 短時間でServiceNow CIS-VR試験に一発合格したいなら、我々社のCiscoのServiceNow CIS-VR資料を参考しましょう。 EMC D-XTR-MN-A-24 - 受験者がOmgzlookを選択したら高度専門の試験に１００％合格することが問題にならないと保証いたします。
Updated: May 28, 2022