Omgzlookは君の成功のために、最も質の良いCiscoの350-401資料的中率試験問題と解答を提供します。もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、Omgzlookは無料でサンプルを提供することができます。あなたはOmgzlookのCiscoの350-401資料的中率問題集を購入した後、私たちは一年間で無料更新サービスを提供することができます。 だから、我々社は力の限りで弊社のCisco 350-401資料的中率試験資料を改善し、改革の変更に応じて更新します。あなたはいつまでも最新版の問題集を使用できるために、ご購入の一年間で無料の更新を提供します。 あなたは弊社の商品を利用して、一回でCiscoの350-401資料的中率試験に合格できなかったら、弊社は全額で返金することを承諾いたします。
CCNP Enterprise 350-401 早くOmgzlookの問題集を君の手に入れましょう。
CCNP Enterprise 350-401資料的中率 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) チャンスはいつも準備ができている人に賦与されると言われます。 君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにOmgzlookを選択してください。Omgzlookはまた一年間に無料なサービスを更新いたします。
Cisco 350-401資料的中率試験を目前に控えて、不安なのですか。我々社のCisco 350-401資料的中率問題集のソフト版を購買するに値するかまだ疑問がありますか。こうしたら、我々Omgzlookの350-401資料的中率問題集デーモを無料にダウンロードして行動してみよう。
Cisco 350-401資料的中率 - 常々、時間とお金ばかり効果がないです。
OmgzlookのCiscoの350-401資料的中率試験トレーニング資料はインターネットでの全てのトレーニング資料のリーダーです。Omgzlookはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。あなたが自分のキャリアでの異なる条件で自身の利点を発揮することを助けられます。
我々の提供する問題集を体験してから、あなたはCiscoの350-401資料的中率試験に合格できる自信を持っています。IT業界で働いている多くの人はCiscoの350-401資料的中率試験の準備が大変だと知っています。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
試験の準備をするためにOmgzlookのCiscoのEMC D-SNC-DY-00試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。 ほかの人がインタネットでゲームを遊んでいるとき、あなたはオンラインでCiscoのScrum PSPO-IIの問題集をすることができます。 真剣にOmgzlookのCisco SASInstitute A00-485問題集を勉強する限り、受験したい試験に楽に合格することができるということです。 このように、客様は我々のJuniper JN0-637問題集を手に入れて勉強したら、試験に合格できるかのを心配することはありません。 Salesforce Data-Cloud-Consultant-JPN - がむしゃらに試験に関連する知識を勉強しているのですか。
Updated: May 28, 2022