そのデモは350-401試験対策書試験資料の一部を含めています。私たちは本当にお客様の貴重な意見を350-401試験対策書試験資料の作りの考慮に入れます。おそらく、君たちは私たちの350-401試験対策書試験資料について何も知らないかもしれません。 OmgzlookのCiscoの350-401試験対策書試験トレーニング資料を持っていたら、試験に対する充分の準備がありますから、安心に利用したください。Omgzlookは優れたIT情報のソースを提供するサイトです。 OmgzlookはCiscoの350-401試験対策書の認定試験の受験生にとっても適合するサイトで、受験生に試験に関する情報を提供するだけでなく、試験の問題と解答をはっきり解説いたします。
それはOmgzlookの350-401試験対策書問題集です。
Omgzlookが提供したCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験対策書の問題集は真実の試験に緊密な相似性があります。 一回だけでCiscoの350-401 模擬問題試験に合格したい？Omgzlookは君の欲求を満たすために存在するのです。Omgzlookは君にとってベストな選択になります。
もし君がCiscoの350-401試験対策書に参加すれば、良い学習のツルを選ぶすべきです。Ciscoの350-401試験対策書認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。。
Cisco 350-401試験対策書 - 我々の誠意を信じてください。
現在でCiscoの350-401試験対策書試験を受かることができます。OmgzlookにCiscoの350-401試験対策書試験のフルバージョンがありますから、最新のCiscoの350-401試験対策書のトレーニング資料をあちこち探す必要がないです。Omgzlookを利用したら、あなたはもう最も良いCiscoの350-401試験対策書のトレーニング資料を見つけたのです。弊社の質問と解答を安心にご利用ください。あなたはきっとCiscoの350-401試験対策書試験に合格できますから。
自分のIT業界での発展を希望したら、Ciscoの350-401試験対策書試験に合格する必要があります。Ciscoの350-401試験対策書試験はいくつ難しくても文句を言わないで、我々Omgzlookの提供する資料を通して、あなたはCiscoの350-401試験対策書試験に合格することができます。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
SAP C_THR88_2405 - この認証は自分のキャリアを強化することができ、自分が成功に近づかせますから。 あなたは自分の望ましいCisco Microsoft PL-300-KR問題集を選らんで、学びから更なる成長を求められます。 ServiceNow CIS-CSM - Omgzlookは毎日異なる受験生に様々なトレーニング資料を提供します。 短時間でDell D-VCFVXR-A-01試験に一発合格したいなら、我々社のCiscoのDell D-VCFVXR-A-01資料を参考しましょう。 Google Cloud-Digital-Leader-JPN - それはあなたがいつでも最新の試験資料を持てるということです。
Updated: May 28, 2022