OmgzlookのCiscoの350-401模擬体験試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの350-401模擬体験問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401模擬体験問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。 ご購入の後、我々はタイムリーにあなたにCiscoの350-401模擬体験ソフトの更新情報を提供して、あなたの備考過程をリラクスにします。Omgzlookの発展は弊社の商品を利用してIT認証試験に合格した人々から得た動力です。 弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoの350-401模擬体験試験に順調に剛角しました。
CCNP Enterprise 350-401 躊躇わなく、行動しましょう。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬体験問題集を利用して試験に合格できます。 350-401 資格試験資格証明書があれば、履歴書は他の人の履歴書より目立つようになります。現在、350-401 資格試験資格証明書の知名度がますます高くなっています。
Omgzlookは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。そして、弊社が提供した問題集を安心で使用して、試験を安心で受けて、君のCisco 350-401模擬体験認証試験の100%の合格率を保証しますす。OmgzlookにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が100%にまで達します。
Cisco 350-401模擬体験 - もし合格しないと、われは全額で返金いたします。
Ciscoの350-401模擬体験試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でOmgzlookは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。
専門的な知識が必要で、もしあなたはまだこの方面の知識を欠かれば、Omgzlookは君に向ける知識を提供いたします。Omgzlookの専門家チームは彼らの知識や経験を利用してあなたの知識を広めることを助けています。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
ITの専門者はCiscoのCompTIA SY0-701認定試験があなたの願望を助けって実現できるのがよく分かります。 CiscoのSplunk SPLK-1005認定試験はOmgzlookの最優秀な専門家チームが自分の知識と業界の経験を利用してどんどん研究した、満足Cisco認証受験生の需要に満たすの書籍がほかのサイトにも見えますが、Omgzlookの商品が最も保障があって、君の最良の選択になります。 Omgzlookの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoのLpi 303-300認定試験対策模擬テスト問題集が研究しました。 Google Professional-Data-Engineer - 弊社は君の試験の100%合格率を保証いたします。 Oracle 1z0-1047-24 - あなたはいつでもサブスクリプションの期間を延長することができますから、より多くの時間を取って充分に試験を準備できます。
Updated: May 28, 2022