その他、我々の350-401最新対策問題日本語問題集を購入すると、英語版を送ります。弊社は350-401最新対策問題問題集の英語版と日本語版をリリースしています。英語版と日本語版の内容は同じですけど、言語だけ違いがあります。 競争力が激しい社会に当たり、我々Omgzlookは多くの受験生の中で大人気があるのは受験生の立場からCisco 350-401最新対策問題試験資料をリリースすることです。たとえば、ベストセラーのCisco 350-401最新対策問題問題集は過去のデータを分析して作成ます。 我が社のサービスもいいです。
我々社の350-401最新対策問題問題集を参考した後、ほっとしました。
CCNP Enterprise 350-401最新対策問題 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。 Cisco 350-401 試験過去問模擬問題集で実際の質問と正確の解答に疑問があれば、無料の練習問題集サンプルをダウンロードし、チェックしてください。我々社のCisco 350-401 試験過去問認定試験問題集の合格率は高いのでほとんどの受験生は350-401 試験過去問認定試験に合格するのを保証します。
Ciscoの350-401最新対策問題試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でOmgzlookは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。
Cisco 350-401最新対策問題 - 我々の誠意を信じてください。
OmgzlookのIT専門家たちは受験生の皆さんのニーズを満たすように彼らの豊富な知識と経験を活かして試験トレーニング資料の品質をずっと高めています。受験生の皆さんが一回でCiscoの350-401最新対策問題試験に合格することを保証します。Omgzlookの製品を購入したら、あなたはいつでも最新かつ最正確な試験情報を得ることができます。Omgzlookの資料のカバー率が高くて、受験生に便宜を与えられます。それに、問題集の合格率が１００パーセントに達するのですから、あなたは安心に試験を受けることができます。
自分のIT業界での発展を希望したら、Ciscoの350-401最新対策問題試験に合格する必要があります。Ciscoの350-401最新対策問題試験はいくつ難しくても文句を言わないで、我々Omgzlookの提供する資料を通して、あなたはCiscoの350-401最新対策問題試験に合格することができます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
EXIN SIAMP - そこで、IT業界で働く人も多くなっています。 弊社のMicrosoft MS-102問題集はあなたにこのチャンスを全面的に与えられます。 最新のSAP C_THR92_2405試験問題を知りたい場合、試験に合格したとしてもOmgzlookは無料で問題集を更新してあげます。 短時間でSAP C-BW4H-2404試験に一発合格したいなら、我々社のCiscoのSAP C-BW4H-2404資料を参考しましょう。 EMC D-PDD-OE-23 - 問題集に含まれているものは実際試験の問題を全部カバーすることができますから、あなたが一回で成功することを保証できます。
Updated: May 28, 2022