弊社は350-401日本語独学書籍問題集の英語版と日本語版をリリースしています。英語版と日本語版の内容は同じですけど、言語だけ違いがあります。それなので、350-401日本語独学書籍に関する英語試験や日本語試験に参加する予定があるご客様は安心に問題集を購入できます。 ほんとんどお客様は我々OmgzlookのCisco 350-401日本語独学書籍問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。競争力が激しい社会に当たり、我々Omgzlookは多くの受験生の中で大人気があるのは受験生の立場からCisco 350-401日本語独学書籍試験資料をリリースすることです。 購入した後、一年間の無料サービス更新を提供します。
我々社の350-401日本語独学書籍問題集を参考した後、ほっとしました。
CCNP Enterprise 350-401日本語独学書籍 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。 もしあなたはCisco 350-401 受験対策試験問題集に十分な注意を払って、350-401 受験対策試験の解答を覚えていれば、350-401 受験対策認定試験の成功は明らかになりました。Cisco 350-401 受験対策模擬問題集で実際の質問と正確の解答に疑問があれば、無料の練習問題集サンプルをダウンロードし、チェックしてください。
Ciscoの350-401日本語独学書籍試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でOmgzlookは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。
Cisco 350-401日本語独学書籍認定試験に合格することは難しいようですね。
Ciscoの350-401日本語独学書籍認定試験は人気があるIT認証に属するもので、野心家としてのIT専門家の念願です。このような受験生は350-401日本語独学書籍認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。
一回だけでCiscoの350-401日本語独学書籍試験に合格したい？Omgzlookは君の欲求を満たすために存在するのです。Omgzlookは君にとってベストな選択になります。
350-401 PDF DEMO:
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
CiscoのH3C GB0-372-ENU試験は挑戦がある認定試験です。 OmgzlookのCiscoのMicrosoft MS-102J試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 CheckPoint 156-587 - Omgzlookが提供した資料は実用性が高くて、絶対あなたに向いています。 Juniper JN0-460 - 時間とお金の集まりより正しい方法がもっと大切です。 HP HPE0-S60J - OmgzlookのIT専門家たちは受験生の皆さんのニーズを満たすように彼らの豊富な知識と経験を活かして試験トレーニング資料の品質をずっと高めています。
Updated: May 28, 2022