350-401日本語版対応参考書はCiscoのひとつの認証で、350-401日本語版対応参考書がCiscoに入るの第一歩として、350-401日本語版対応参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験がますます人気があがって、350-401日本語版対応参考書に参加するかたもだんだん多くなって、しかし350-401日本語版対応参考書認証試験に合格することが非常に難しいで、君は350-401日本語版対応参考書に関する試験科目の問題集を購入したいですか？ Ciscoの350-401日本語版対応参考書認定試験は実は技術専門家を認証する試験です。Ciscoの350-401日本語版対応参考書認定試験はIT人員が優れたキャリアを持つことを助けられます。 Omgzlookは提供した商品は君の成功を全力で助けさしたげます。
CCNP Enterprise 350-401 でも、成功へのショートカットがを見つけました。
CCNP Enterprise 350-401日本語版対応参考書 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 きっと望んでいるでしょう。では、常に自分自身をアップグレードする必要があります。
弊社が提供した問題集がほかのインターネットに比べて問題のカーバ範囲がもっと広くて対応性が強い長所があります。Omgzlookが持つべきなIT問題集を提供するサイトでございます。
Cisco 350-401日本語版対応参考書 - もちろんありますよ。
OmgzlookのCiscoの350-401日本語版対応参考書試験のトレーニングキットはOmgzlookのIT技術専門家たちによって開発されたのです。そのデザインは当面の急速に変化するIT市場と密接な関係があります。Omgzlookのトレーニングはあなたを助けて継続的に発展している技術を利用して、問題を解決する能力を高めると同時に仕事についての満足度を向上させることができます。OmgzlookのCiscoの350-401日本語版対応参考書の認証したカバー率は１００パーセントに達したのですから、弊社の問題と解答を利用する限り、あなたがきっと気楽に試験に合格することを保証します。
君がCiscoの350-401日本語版対応参考書問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401日本語版対応参考書問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
Cisco 700-245 - 最もプロな人々が注目しているIT専門家になりたかったら、後悔しないように速くショッピングカートを入れましょう。 弊社のOmgzlookはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoのSAP C-S4EWM-2023試験問題集を提供いたします。 Amazon CLF-C02 - Omgzlookがデザインしたトレーニングツールはあなたが一回で試験に合格することにヘルプを差し上げられます。 ACFE CFE-JPN - これをよくできるために、我々は全日24時間のサービスを提供します。 全てのIT専門人員はCiscoのBCS TTA-19の認定試験をよく知っていて、その難しい試験に受かることを望んでいます。
Updated: May 28, 2022