なぜ我々のCiscoの350-401日本語版参考書ソフトに自信があるかと聞かれたら、まずは我々Omgzlookの豊富な経験があるチームです、次は弊社の商品を利用してCiscoの350-401日本語版参考書試験に合格する多くのお客様です。Ciscoの350-401日本語版参考書試験は国際的に認められてあなたはこの認証がほしいですか。弊社のCiscoの350-401日本語版参考書試験のソフトを通して、あなたはリラクスで得られます。 Omgzlookの専門家チームがCiscoの350-401日本語版参考書認証試験に対して最新の短期有効なトレーニングプログラムを研究しました。Ciscoの350-401日本語版参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に参加者に対して30時間ぐらいの短期の育成訓練でらくらくに勉強しているうちに多くの知識を身につけられます。 Ciscoの350-401日本語版参考書試験に合格するためにたくさんの方法がありますが、我々Omgzlookの提供する方法は一番効果的なのです。
CCNP Enterprise 350-401 きっと君に失望させないと信じています。
しかしも、品質はもっと高くて一度350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語版参考書試験に合格したい客様に対して、我が社の350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語版参考書はあなたの最高選択かつ成功のショートカットであると思われます。 我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。Omgzlook Ciscoの350-401 試験問題解説集試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。
我々OmgzlookはCiscoの350-401日本語版参考書試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401日本語版参考書試験問題集を開発するのに準備します。
Cisco 350-401日本語版参考書 - 素晴らしい試験参考書です。
IT認定試験の中でどんな試験を受けても、Omgzlookの350-401日本語版参考書試験参考資料はあなたに大きなヘルプを与えることができます。それは Omgzlookの350-401日本語版参考書問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。真剣にOmgzlookのCisco 350-401日本語版参考書問題集を勉強する限り、受験したい試験に楽に合格することができるということです。
弊社は強力な教師チームがあって、彼たちは正確ではやくて例年のCisco 350-401日本語版参考書認定試験の資料を整理して、直ちにもっとも最新の資料を集めて、弊社は全会一緻で認められています。Cisco 350-401日本語版参考書試験認証に合格確率はとても小さいですが、Omgzlookはその合格確率を高めることが信じてくだい。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
SAP C-BW4H-2404 - がむしゃらに試験に関連する知識を勉強しているのですか。 EMC D-SNC-DY-00 - Omgzlookが提供した資料は最も全面的で、しかも更新の最も速いです。 OmgzlookのCiscoのISTQB CTAL-TTA試験トレーニング資料を使ったら、君のCiscoのISTQB CTAL-TTA認定試験に合格するという夢が叶えます。 Omgzlookが提供した教材を勉強ツルとしてCiscoのVMware 3V0-61.24認定試験に合格するのはとても簡単です。 Lpi 303-300 - それは正確性が高くて、カバー率も広いです。
Updated: May 28, 2022