あなたは無料で350-401復習テキスト復習教材をダウンロードしたいですか？もちろん、回答ははいです。だから、あなたはコンピューターでCiscoのウエブサイトを訪問してください。そうすれば、あなたは簡単に350-401復習テキスト復習教材のデモを無料でダウンロードできます。 あなたが信じる信じられないのを問わず、我々の権威的なCiscoの350-401復習テキスト試験のための資料がここにあります。あなたにCiscoの350-401復習テキスト試験準備の最高のヘルプを提供します。 君はオンラインで無料な練習問題をダウンロードできて、１００％で試験に合格しましょう。
CCNP Enterprise 350-401 「信仰は偉大な感情で、創造の力になれます。
CCNP Enterprise 350-401復習テキスト - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 弊社の商品が好きなのは弊社のたのしいです。 あなたの夢は何ですか。あなたのキャリアでいくつかの輝かしい業績を行うことを望まないのですか。
OmgzlookはもっぱらITプロ認証試験に関する知識を提供するのサイトで、ほかのサイト使った人はOmgzlookが最高の知識源サイトと比較しますた。Omgzlookの商品はとても頼もしい試験の練習問題と解答は非常に正確でございます。
Cisco 350-401復習テキスト - もちろんありますよ。
Omgzlookがもっと早くCiscoの350-401復習テキスト認証試験に合格させるサイトで、Ciscoの350-401復習テキスト認証試験についての問題集が市場にどんどん湧いてきます。あなたがまだ専門知識と情報技術を証明しています強い人材で、OmgzlookのCiscoの350-401復習テキスト認定試験について最新の試験問題集が君にもっとも助けていますよ。
OmgzlookのCiscoの350-401復習テキスト試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの350-401復習テキスト問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
CompTIA FC0-U61J - だからいろいろな方は試験を借って、自分の社会の地位を固めたいです。 Oracle 1Z0-902 - もし弊社のソフトを使ってあなたは残念で試験に失敗したら、弊社は全額で返金することを保証いたします。 現在のネットワークの全盛期で、CiscoのSAP C_SIGDA_2403の認証試験を準備するのにいろいろな方法があります。 SAP C_ARSCC_2404 - 試験に失敗したら、全額で返金する承諾があります。 Adobe AD0-E126認定試験の真実の問題に会うかもしれません。
Updated: May 28, 2022