Ciscoの350-401専門知識内容試験に受かるのはあなたが自分をIT業種にアピールする方法の一つです。でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、OmgzlookのCiscoの350-401専門知識内容試験トレーニング資料を選んだらいいです。Omgzlookのトレーニング資料はIT認証試験に受かるために特別に研究されたものですから、この資料を手に入れたら難しいCiscoの350-401専門知識内容認定試験に気楽に合格することができるようになります。 弊社の商品が好きなのは弊社のたのしいです。Omgzlookはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。 そうだったら、Omgzlookを利用したください。
CCNP Enterprise 350-401 Omgzlookを選んだら、成功への扉を開きます。
CCNP Enterprise 350-401専門知識内容 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 心よりご成功を祈ります。 このような素晴らしい資料をぜひ見逃さないでください。IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。
豊富な資料、便利なページ構成と購入した一年間の無料更新はあなたにCiscoの350-401専門知識内容試験に合格させる最高の支持です。あなたのIT能力が権威的に認められるのがほしいですか。Ciscoの350-401専門知識内容試験に合格するのは最良の方法の一です。
Cisco 350-401専門知識内容 - あなたの愛用する版をやってみよう。
なぜ受験生のほとんどはOmgzlookを選んだのですか。それはOmgzlookがすごく便利で、広い通用性があるからです。OmgzlookのITエリートたちは彼らの専門的な目で、最新的なCiscoの350-401専門知識内容試験トレーニング資料に注目していて、うちのCiscoの350-401専門知識内容問題集の高い正確性を保証するのです。もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、Omgzlookは無料でサンプルを提供することができます。
ご客様は弊社の350-401専門知識内容問題集を購入するかどうかと判断する前に、我が社は無料に提供するサンプルをダウンロードして試すことができます。それで、不必要な損失を避けできます。
350-401 PDF DEMO:
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
CiscoのEMC D-CS-DS-23認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。 あなたは弊社OmgzlookのCisco SAP C-THR95-2405試験問題集を利用し、試験に一回合格しました。 弊社のCiscoのMicrosoft AZ-800Jソフトを購入するのを決めるとき、我々は各方面であなたに保障を提供します。 Cisco SAP C_LIXEA_2404問題集の購買に何か質問があれば、我々の職員は皆様のお問い合わせを待っています。 試験が更新されているうちに、我々はCiscoのCWNP CWT-101試験の資料を更新し続けています。
Updated: May 28, 2022