Omgzlookはあなたが必要とするすべての350-401実際試験参考資料を持っていますから、きっとあなたのニーズを満たすことができます。Omgzlookのウェブサイトに行ってもっとたくさんの情報をブラウズして、あなたがほしい試験350-401実際試験参考書を見つけてください。350-401実際試験認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。 そのデザインは当面の急速に変化するIT市場と密接な関係があります。Omgzlookのトレーニングはあなたを助けて継続的に発展している技術を利用して、問題を解決する能力を高めると同時に仕事についての満足度を向上させることができます。 君がCiscoの350-401実際試験問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。
CCNP Enterprise 350-401 我々もオンライン版とソフト版を提供します。
CCNP Enterprise 350-401実際試験 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlook は世界的によく知られているサイトです。 我々OmgzlookはCiscoの350-401 基礎問題集試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401 基礎問題集試験問題集を開発するのに準備します。
Omgzlookを利用したら、あなたはきっと高い点数を取ることができ、あなたの理想なところへと進むことができます。IT認証資料を提供したほかのサイトより、Omgzlookのプロかつ高品質の製品は最高のものです。Omgzlookを選んだら成功を選んだということです。
Cisco 350-401実際試験 - しかし、資料の品質が保証されることができません。
Ciscoの350-401実際試験試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でOmgzlookは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。
もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。OmgzlookのCiscoの350-401実際試験試験トレーニング資料は正確性が高くて、カバー率も広い。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
ITの専門者はCiscoのMicrosoft SC-400J認定試験があなたの願望を助けって実現できるのがよく分かります。 OmgzlookのCiscoのDell D-VCFVXR-A-01試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 Omgzlookの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoのOracle 1z0-1042-24認定試験対策模擬テスト問題集が研究しました。 CiscoのISQI CTAL-TTA_Syll19_4.0試験は、ITに関する仕事に就職している人々にとって、重要な能力への証明ですが、難しいです。 SASInstitute A00-470 - あなたはいつでもサブスクリプションの期間を延長することができますから、より多くの時間を取って充分に試験を準備できます。
Updated: May 28, 2022