OmgzlookのCiscoの350-401学習関連題試験問題資料は質が良くて値段が安い製品です。我々は低い価格と高品質の模擬問題で受験生の皆様に捧げています。我々は心からあなたが首尾よく試験に合格することを願っています。 350-401学習関連題はCiscoのひとつの認証で、350-401学習関連題がCiscoに入るの第一歩として、350-401学習関連題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験がますます人気があがって、350-401学習関連題に参加するかたもだんだん多くなって、しかし350-401学習関連題認証試験に合格することが非常に難しいで、君は350-401学習関連題に関する試験科目の問題集を購入したいですか？ 優れたキャリアを持ったら、社会と国のために色々な利益を作ることができて、国の経済が継続的に発展していることを進められるようになります。
CCNP Enterprise 350-401 さて、はやく試験を申し込みましょう。
CCNP Enterprise 350-401学習関連題 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookが持つべきなIT問題集を提供するサイトでございます。 Omgzlookの350-401 ミシュレーション問題教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。試験問題集が更新されると、Omgzlookは直ちにあなたのメールボックスに350-401 ミシュレーション問題問題集の最新版を送ります。
IT業の多くの人がいくつか認証試験にパスしたくて、それなりの合格証明書が君に最大な上昇空間を与えます。この競争の激しい業界でとんとん拍子に出世させるのはCiscoの350-401学習関連題認定試験ですが、簡単にパスではありません。でもたくさんの方法があって、最も少ない時間をエネルギーをかかるのは最高です。
Cisco 350-401学習関連題 - 試験に失敗したら、全額で返金する承諾があります。
全てのIT専門人員はCiscoの350-401学習関連題の認定試験をよく知っていて、その難しい試験に受かることを望んでいます。Ciscoの350-401学習関連題の認定試験の認可を取ったら、あなたは望むキャリアを得ることができるようになります。OmgzlookのCiscoの350-401学習関連題試験トレーニング資料を利用したら、望むことを取得できます。
暇な時間だけでCiscoの350-401学習関連題試験に合格したいのですか。我々の提供するPDF版のCiscoの350-401学習関連題試験の資料はあなたにいつでもどこでも読めさせます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
それはOmgzlookのCiscoのEMC D-CIS-FN-23試験トレーニング資料は適用性が高いもので、本当にみなさんが良い成績を取ることを助けられるからです。 我々OmgzlookはCiscoのFortinet NSE5_FSM-6.3試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。 Microsoft AZ-700J - Omgzlookを選んだら成功を選んだということです。 たとえば、ベストセラーのCisco EMC D-PVM-DS-23問題集は過去のデータを分析して作成ます。 OmgzlookはIT認定試験に関連する資料の専門の提供者として、受験生の皆さんに最も優秀な試験Oracle 1z0-1042-24参考書を提供することを目標としています。
Updated: May 28, 2022