あなたが首尾よく試験に合格するように、我々は最も有利な価格と最高のクオリティーを提供して差し上げます。Omgzlookは我々が研究したトレーニング資料を無料に更新します。それはあなたがいつでも最新の350-401問題と解答試験トレーニング資料をもらえるということです。 OmgzlookにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 350-401問題と解答認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにOmgzlookを選択してください。 OmgzlookのCiscoの350-401問題と解答試験トレーニング資料はあなたが完全に問題と問題に含まれているコンセプトを理解できることを保証しますから、あなたは気楽に一回で試験に合格することができます。
CCNP Enterprise 350-401 まず問題集のdemoを体験することができます。
CCNP Enterprise 350-401問題と解答 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。 実際は試験に合格するコツがあるのですよ。もし試験に準備するときに良いツールを使えば、多くの時間を節約することができるだけでなく、楽に試験に合格する保障を手にすることもできます。
あるいは、無料で試験350-401問題と解答問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。Omgzlookの350-401問題と解答問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。
Cisco 350-401問題と解答 - できるだけ100％の通過率を保証使用にしています。
我々Omgzlookが数年以来商品の開発をしている目的はIT業界でよく発展したい人にCiscoの350-401問題と解答試験に合格させることです。Ciscoの350-401問題と解答試験のための資料がたくさんありますが、Omgzlookの提供するのは一番信頼できます。我々の提供するソフトを利用する人のほとんどは順調にCiscoの350-401問題と解答試験に合格しました。その中の一部は暇な時間だけでCiscoの350-401問題と解答試験を準備します。
ただ、社会に入るIT卒業生たちは自分能力の不足で、350-401問題と解答試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの350-401問題と解答練習問題を選んで実用能力を速く高め、自分を充実させます。その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調に350-401問題と解答向けの会社に入ります。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
CiscoのFortinet NSE6_WCS-7.0試験の資料についてあなたは何か問題があったら、それとも、ほかの試験ソフトに興味があったら、直ちにオンラインで我々を連絡したり、メールで問い合わせたりすることができます。 OmgzlookのCisco Cisco 300-730J問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。 弊社のSASInstitute A00-282真題を入手して、試験に合格する可能性が大きくなります。 Cisco HP HPE6-A72試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。 我々Huawei H13-511_V5.5問題集を利用し、試験に参加しましょう。
Updated: May 28, 2022