でも、どのように350-401合格率認定試験に合格しますか？もちろん、350-401合格率問題集を選ぶべきです。選ぶ理由はなんですか？お客様に350-401合格率認定試験資料を提供してあげ、勉強時間は短くても、合格できることを保証いたします。不合格になる場合は、全額返金することを保証いたします。 あなたは350-401合格率試験に不安を持っていますか？350-401合格率参考資料をご覧下さい。私たちの350-401合格率参考資料は十年以上にわたり、専門家が何度も練習して、作られました。 この世界は毎日変わっています。
CCNP Enterprise 350-401 早くOmgzlookの問題集を君の手に入れましょう。
CCNP Enterprise 350-401合格率 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) たくさんのひとは弊社の商品を使って、試験に順調に合格しました。 君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにOmgzlookを選択してください。Omgzlookはまた一年間に無料なサービスを更新いたします。
この情報の時代の中に、たくさんのIT機構はCiscoの350-401合格率認定試験に関する教育資料がありますけれども、受験生がこれらのサイトを通じて詳細な資料を調べられなくて、対応性がなくて受験生の注意 に惹かれなりません。
Cisco 350-401合格率 - そうすると、我々の信頼性をテストできます。
なぜ受験生のほとんどはOmgzlookを選んだのですか。それはOmgzlookがすごく便利で、広い通用性があるからです。OmgzlookのITエリートたちは彼らの専門的な目で、最新的なCiscoの350-401合格率試験トレーニング資料に注目していて、うちのCiscoの350-401合格率問題集の高い正確性を保証するのです。もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、Omgzlookは無料でサンプルを提供することができます。
そうしたら、試験に受かる信心も持つようになります。OmgzlookのCiscoの350-401合格率試験トレーニング資料は特別に受験生を対象として研究されたものです。
350-401 PDF DEMO:
QUESTION NO: 1
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID
QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
CiscoのJuniper JN0-452認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。 EMC D-PCR-DY-23 - この試験の認証資格を取ったら、あなたは多くの利益を得ることができます。 Network Appliance NS0-304 - 常々、時間とお金ばかり効果がないです。 Splunk SPLK-1002 - ですから、心のリラックスした状態で試験に出る問題を対応することができ、あなたの正常なレベルをプレイすることもできます。 Omgzlookは多くの受験生を助けて彼らにCiscoのEMC D-XTR-OE-A-24試験に合格させることができるのは我々専門的なチームがCiscoのEMC D-XTR-OE-A-24試験を研究して解答を詳しく分析しますから。
Updated: May 28, 2022