簡単で順調にCisco 350-401合格率書籍認定試験を通すのは問題になりますが、Omgzlookはこの問題を解決できるよ。弊社の問題集はIT技術者がこつこつ研究して、正確で最新なもので君の350-401合格率書籍認定試験を簡単に通すことにいいトレーニングツールになりますよ。Omgzlookを選られば、成功しましょう。 Ciscoの350-401合格率書籍の認定試験は君の実力を考察するテストでございます。Ciscoの350-401合格率書籍の認定試験に合格すれば、就職機会が多くなります。 弊社の勉強の商品を選んで、多くの時間とエネルギーを節約こともできます。
CCNP Enterprise 350-401 それは受験者にとって重要な情報です。
インターネットで時勢に遅れない350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格率書籍勉強資料を提供するというサイトがあるかもしれませんが、Omgzlookはあなたに高品質かつ最新のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格率書籍トレーニング資料を提供するユニークなサイトです。 弊社の無料なサンプルを遠慮なくダウンロードしてください。君はまだCiscoの350-401 再テスト認証試験を通じての大きい難度が悩んでいますか？ 君はまだCisco 350-401 再テスト認証試験に合格するために寝食を忘れて頑張って復習しますか？ 早くてCisco 350-401 再テスト認証試験を通りたいですか？Omgzlookを選択しましょう！
Omgzlookが提供したCiscoの350-401合格率書籍トレーニング資料を利用したら、Ciscoの350-401合格率書籍認定試験に受かることはたやすくなります。Omgzlookがデザインしたトレーニングツールはあなたが一回で試験に合格することにヘルプを差し上げられます。OmgzlookのCiscoの350-401合格率書籍トレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。
その中で、Cisco 350-401合格率書籍認定試験は最も重要な一つです。
神様は私を実力を持っている人間にして、美しい人形ではないです。IT業種を選んだ私は自分の実力を証明したのです。しかし、神様はずっと私を向上させることを要求します。Ciscoの350-401合格率書籍試験を受けることは私の人生の挑戦の一つです。でも大丈夫です。OmgzlookのCiscoの350-401合格率書籍試験トレーニング資料を購入しましたから。すると、Ciscoの350-401合格率書籍試験に合格する実力を持つようになりました。 OmgzlookのCiscoの350-401合格率書籍試験トレーニング資料を持つことは明るい未来を持つことと同じです。
なぜなら、それはCiscoの350-401合格率書籍認定試験に関する必要なものを含まれるからです。Omgzlookを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。
350-401 PDF DEMO:
QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
Salesforce Advanced-Administrator-JPN - そうすると、きっと私の言葉を信じるようになります。 OmgzlookのCiscoのMicrosoft SC-200試験トレーニング資料はCiscoのMicrosoft SC-200認定試験を準備するのリーダーです。 HP HPE7-A05 - もし一つの認証資格を持っていないなら、IT認定試験を申し込んで試験の資格を取得する必要があります。 もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoのOracle 1z0-1072-24試験のソフトウェアです。 Network Appliance NS0-304 - IT領域でも同じです。
Updated: May 28, 2022