あなたに安心にネットでCiscoの350-401合格率書籍試験の資料を購入させるために、我々Omgzlookは国際の最大の安全的な支払システムPaypalと協力してあなたの支払の安全性を保障します。支払ってから、あなたは直ちにCiscoの350-401合格率書籍試験の資料をダウンロードすることができ、その後の一年間でCiscoの350-401合格率書籍試験ソフトが更新されたら、我々はあなたを通知します。Omgzlookを選ぶのは最高のサービスを選んだことです。 OmgzlookのCiscoの350-401合格率書籍試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの350-401合格率書籍問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。 心配なく我々の真題を利用してください。
CCNP Enterprise 350-401 試験に失敗したら、全額で返金する承諾があります。
弊社のCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格率書籍問題集を通して復習してから、真実的に自分の能力の向上を感じ、350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格率書籍資格認定を受け取ります。 我々の提供するPDF版のCiscoの350-401 受験対策解説集試験の資料はあなたにいつでもどこでも読めさせます。我々もオンライン版とソフト版を提供します。
350-401合格率書籍問題集は全面的かつわかりやすいです。あなたは350-401合格率書籍問題集をちゃんと覚えると、350-401合格率書籍試験に合格することは簡単です。では、試験を心配するより、今から行動しましょう。
Cisco 350-401合格率書籍 - 試験に失敗したら、全額で返金いたします。
どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの350-401合格率書籍認定試験があなたの願望を助けって実現できるのがよく分かります。Omgzlookはあなたの夢に実現させるサイトでございます。
君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにOmgzlookを選択してください。Omgzlookはまた一年間に無料なサービスを更新いたします。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
Salesforce CRT-261J - 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 Amazon DVA-C02-JPN - Omgzlookの問題と解答は初めに試験を受けるあなたが気楽に成功することを助けるだけではなく、あなたの貴重な時間を節約することもできます。 SAP C_TS412_2021-JPN - あなたに向いていることを確かめてから買うのも遅くないですよ。 Omgzlookは専門的にCiscoのCompTIA PK0-005J試験の最新問題と解答を提供するサイトで、CompTIA PK0-005Jについての知識をほとんどカバーしています。 Omgzlookはとても良い選択で、SAP C-THR92-2405の試験を最も短い時間に縮められますから、あなたの費用とエネルギーを節約することができます。
Updated: May 28, 2022