多くの人々はCiscoの350-401合格体験談試験に合格できるのは難しいことであると思っています。この悩みに対して、我々社OmgzlookはCiscoの350-401合格体験談試験に準備するあなたに専門的なヘルプを与えられます。弊社のCiscoの350-401合格体験談練習問題を利用したら、あなたは気楽に勉強するだけではなく、順調に試験に合格します。 試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。しかも、一年間の無料更新サービスを提供します。 弊社の高品質の試験問題集を通して、あなたにCisco 350-401合格体験談試験似合格させ、あなたのIT技能と職業生涯を新たなレベルに押し進めるのは我々の使命です。
CCNP Enterprise 350-401 それはあなたが夢を実現することを助けられます。
CCNP Enterprise 350-401合格体験談 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Omgzlookはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。 さて、はやく試験を申し込みましょう。Omgzlookはあなたを助けることができますから、心配する必要がないですよ。
OmgzlookはもっぱらITプロ認証試験に関する知識を提供するのサイトで、ほかのサイト使った人はOmgzlookが最高の知識源サイトと比較しますた。Omgzlookの商品はとても頼もしい試験の練習問題と解答は非常に正確でございます。
Cisco 350-401合格体験談 - 準備することが時間と労力がかかります。
350-401合格体験談認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。しかし、350-401合格体験談認定試験を受けて資格を得ることは自分の技能を高めてよりよく自分の価値を証明する良い方法ですから、選択しなければならならないです。ところで、受験生の皆さんを簡単にIT認定試験に合格させられる方法がないですか。もちろんありますよ。Omgzlookの問題集を利用することは正にその最良の方法です。Omgzlookはあなたが必要とするすべての350-401合格体験談参考資料を持っていますから、きっとあなたのニーズを満たすことができます。Omgzlookのウェブサイトに行ってもっとたくさんの情報をブラウズして、あなたがほしい試験350-401合格体験談参考書を見つけてください。
Omgzlookがもっと早くCiscoの350-401合格体験談認証試験に合格させるサイトで、Ciscoの350-401合格体験談認証試験についての問題集が市場にどんどん湧いてきます。あなたがまだ専門知識と情報技術を証明しています強い人材で、OmgzlookのCiscoの350-401合格体験談認定試験について最新の試験問題集が君にもっとも助けていますよ。
350-401 PDF DEMO:
QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.
QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").
QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
君がCiscoのSAP C_TS414_2023問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。 ACAMS CAMS-KR認定試験はCiscoの中に重要な認証試験の一つですが、OmgzlookにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco ACAMS CAMS-KR認証試験に参加する方に対して問題集を研究続けています。 弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoのHP HPE0-V25試験に順調に剛角しました。 Omgzlookが提供した最も依頼できるトレーニングの問題と解答はあなたが気楽にCiscoのHP HPE0-V25の認証試験を受かることに助けを差し上げます。 SAP C_C4H620_34 - これをよくできるために、我々は全日24時間のサービスを提供します。
Updated: May 28, 2022