Ciscoの350-401受験体験の認証試験について、あなたは異なるサイトや書籍で色々な問題を見つけることができます。しかし、ロジックが接続されているかどうかはキーです。Omgzlookの問題と解答は初めに試験を受けるあなたが気楽に成功することを助けるだけではなく、あなたの貴重な時間を節約することもできます。 OmgzlookのCiscoの350-401受験体験の試験問題は同じシラバスに従って、実際のCiscoの350-401受験体験認証試験にも従っています。弊社はずっとトレーニング資料をアップグレードしていますから、提供して差し上げた製品は一年間の無料更新サービスの景品があります。 Omgzlookは専門的にCiscoの350-401受験体験試験の最新問題と解答を提供するサイトで、350-401受験体験についての知識をほとんどカバーしています。
CCNP Enterprise 350-401 近年、IT領域で競争がますます激しくなります。
Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験体験認定試験に関する研究資料が重要な一部です。 OmgzlookのCiscoの350-401 模擬資料試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。Omgzlookに会ったら、最高のトレーニング資料を見つけました。
それもほとんどの受験生はOmgzlookを選んだ理由です。Omgzlookはいつまでも受験生のニーズに注目していて、できるだけ皆様のニーズを満たします。OmgzlookのCiscoの350-401受験体験試験トレーニング資料は今までがないIT認証のトレーニング資料ですから、Omgzlookを利用したら、あなたのキャリアは順調に進むことができるようになります。
Cisco 350-401受験体験 - 進歩を勇敢に追及する人生こそ素晴らしい人生です。
350-401受験体験認定試験に合格することは難しいようですね。試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。そうだったら、下記のものを読んでください。いま350-401受験体験試験に合格するショートカットを教えてあげますから。あなたを試験に一発合格させる素晴らしい350-401受験体験試験に関連する参考書が登場しますよ。それはOmgzlookの350-401受験体験問題集です。気楽に試験に合格したければ、はやく試しに来てください。
IT認定試験の出題範囲に対して、Omgzlookは豊富な経験を持っています。また、Omgzlookは数え切れない受験生を助け、皆さんの信頼と称賛を得ました。
350-401 PDF DEMO:
QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
OmgzlookのCiscoのCisco 820-605問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。 SAP C-LIXEA-2404 - この問題集は絶対あなたがずっと探しているものです。 OmgzlookのCiscoのAmazon DOP-C02-JPN試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 CiscoのECCouncil 212-82認証資格を取得すると、あなたは大きなヘルプを得ることができます。 Salesforce Data-Cloud-Consultant - 我々の誠意を信じてください。
Updated: May 28, 2022