IT業界で働いている多くの人はCiscoの350-401勉強の資料試験の準備が大変だと知っています。我々Omgzlookは350-401勉強の資料試験の難しさを減らないとは言え、試験準備の難しさを減ることができます。我々の提供する問題集を体験してから、あなたはCiscoの350-401勉強の資料試験に合格できる自信を持っています。 試験の準備をするためにOmgzlookのCiscoの350-401勉強の資料試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。一番遠いところへ行った人はリスクを背負うことを恐れない人です。 ほかの人がインタネットでゲームを遊んでいるとき、あなたはオンラインでCiscoの350-401勉強の資料の問題集をすることができます。
CCNP Enterprise 350-401 早速買いに行きましょう。
次のジョブプロモーション、プロジェクタとチャンスを申し込むとき、Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)勉強の資料資格認定はライバルに先立つのを助け、あなたの大業を成し遂げられます。 OmgzlookのCiscoの350-401 参考書内容試験トレーニング資料はCiscoの350-401 参考書内容認定試験を準備するのリーダーです。Omgzlookの Ciscoの350-401 参考書内容試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。
あなたは350-401勉強の資料試験に興味を持たれば、今から行動し、350-401勉強の資料練習問題を買いましょう。350-401勉強の資料試験に合格するために、350-401勉強の資料練習問題をよく勉強すれば、いい成績を取ることが難しいことではありません。つまり350-401勉強の資料練習問題はあなたの最も正しい選択です。
だから、Cisco 350-401勉強の資料復習教材を買いました。
我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。Ciscoの350-401勉強の資料の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの350-401勉強の資料試験に一番信頼できるヘルプを提供します。Ciscoの350-401勉強の資料試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。
あなたはその他のCisco 350-401勉強の資料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に関するツールサイトでも見るかも知れませんが、弊社はIT業界の中で重要な地位があって、Omgzlookの問題集は君に100%で合格させることと君のキャリアに変らせることだけでなく一年間中で無料でサービスを提供することもできます。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
自分の能力を証明するために、CompTIA N10-008J試験に合格するのは不可欠なことです。 Omgzlookを通じて最新のCiscoのAmazon ANS-C01試験の問題と解答早めにを持てて、弊社の問題集があればきっと君の強い力になります。 Cisco 100-490J - 我々Omgzlookは一番行き届いたアフタサービスを提供します。 Omgzlookが提供した研修ツールはCiscoのCompTIA SY0-601-JPNの認定試験に向けて学習資料やシミュレーション訓練宿題で、重要なのは試験に近い練習問題と解答を提供いたします。 我々社サイトのCisco Cisco 200-201J問題庫は最新かつ最完備な勉強資料を有して、あなたに高品質のサービスを提供するのはCisco 200-201J資格認定試験の成功にとって唯一の選択です。
Updated: May 28, 2022