Ciscoの350-401予想試験試験トレーニングソースを提供するサイトがたくさんありますが、Omgzlookは最実用な資料を提供します。Omgzlookには専門的なエリート団体があります。認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの350-401予想試験試験を研究していますから、Ciscoの350-401予想試験認定試験に受かりたかったら、Omgzlookのサイトをクッリクしてください。 はやくOmgzlookのサイトを登録してくだい。きっと棚ぼたがありますよ。 OmgzlookのCiscoの350-401予想試験試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。
CCNP Enterprise 350-401 君は成功の道にもっと近くなります。
CCNP Enterprise 350-401予想試験 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 常々、時間とお金ばかり効果がないです。 Omgzlookを選びましょう。私たちは君のIT技能を増強させられますし、君の簡単にCiscoの350-401 日本語版問題解説認定試験に合格することができます。
Omgzlookは多くの受験生を助けて彼らにCiscoの350-401予想試験試験に合格させることができるのは我々専門的なチームがCiscoの350-401予想試験試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401予想試験試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。
Cisco 350-401予想試験 - Omgzlookはあなたの信頼を得る足ります。
IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。Cisco 350-401予想試験試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。それで、我々社の無料のCisco 350-401予想試験デモを参考して、あなたに相応しい問題集を入手します。暇の時間を利用して勉強します。努力すれば報われますなので、Cisco 350-401予想試験資格認定を取得して自分の生活状況を改善できます。
それに、これらの資料は我々Omgzlookのウェブサイトで見つけることができます。時には、進める小さなステップは人生の中での大きなステップとするかもしれません。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
そして、SAP C_ARP2P_2404試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。 CompTIA CAS-004-JPN - 時間が経つとともに、我々はインタネット時代に生活します。 Microsoft AZ-204 - この試験に合格すれば君の専門知識がとても強いを証明し得ます。 あなたは十分の時間でCisco 350-201試験を準備することができます。 きみはCiscoのITIL ITIL-4-Foundation認定テストに合格するためにたくさんのルートを選択肢があります。
Updated: May 28, 2022