350-401テスト問題集 - 350-401関連資格知識 & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Omgzlook

そうしたらOmgzlookのCiscoの350-401テスト問題集試験に合格することができるようになります。OmgzlookのCiscoの350-401テスト問題集試験に合格することはあなたのキャリアを助けられて、将来の異なる環境でチャンスを与えます。OmgzlookのCiscoの350-401テスト問題集試験トレーニング資料はあなたが完全に問題と問題に含まれているコンセプトを理解できることを保証しますから、あなたは気楽に一回で試験に合格することができます。 Omgzlook のCiscoの350-401テスト問題集問題集はシラバスに従って、それに350-401テスト問題集認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。弊社の350-401テスト問題集のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。 Omgzlookはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。

CCNP Enterprise 350-401 あなたの能力は彼らうより弱いですか。

CCNP Enterprise 350-401テスト問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。 どんなツールかと聞きたいでしょう。それはもちろんOmgzlookの350-401 受験資格問題集ですよ。

Omgzlookの350-401テスト問題集問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、Omgzlookは全額で返金することができます。あるいは、無料で試験350-401テスト問題集問題集を更新してあげるのを選択することもできます。

Cisco 350-401テスト問題集 - 常々、時間とお金ばかり効果がないです。

我々は販売者とお客様の間の信頼が重要でもらい難いのを知っています。我々はCiscoの350-401テスト問題集ソフトであなたに専門と高効率を示して、最全面的な問題集と詳しい分析であなたに助けてCiscoの350-401テスト問題集試験に合格して、最高のサービスであなたの信頼を得ています。あなたが試験に合格するのは我々への一番よい評価です。

Omgzlookは多くの受験生を助けて彼らにCiscoの350-401テスト問題集試験に合格させることができるのは我々専門的なチームがCiscoの350-401テスト問題集試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401テスト問題集試験の資料を更新し続けています。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

CiscoのAPI API-510試験のための資料がたくさんありますが、Omgzlookの提供するのは一番信頼できます。 その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調にJuniper JN0-1103向けの会社に入ります。 あなたに安心にCiscoのSAP C-ARP2P-2404ソフトを購入させるために、我々は最も安全的な支払手段を提供します。 我々H3C GB0-372-ENU問題集の通過率は高いので、90%の合格率を保証します。 なぜならば、IT職員にとって、CiscoのHP HP2-I58資格証明書があるのは肝心な指標であると言えます。

Updated: May 28, 2022