350-401シュミレーション問題集 - Cisco 350-401認定資格 & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Omgzlook

Omgzlookを選んだら、成功への扉を開きます。頑張ってください。人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。 Omgzlookを手にすると、あなたは安心に試験の準備に身を投げられるようになります。Omgzlookは高品質なトレーニング資料を提供して、あなたが試験に合格することを保証します。 IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。

CCNP Enterprise 350-401 正しい方法は大切です。

CCNP Enterprise 350-401シュミレーション問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) このソフトで、あなたは事前に実際の試験を感じることができます。 試験が更新されているうちに、我々はCiscoの350-401 資格準備試験の資料を更新し続けています。できるだけ100%の通過率を保証使用にしています。

Omgzlookの350-401シュミレーション問題集問題集は実際の350-401シュミレーション問題集認定試験と同じです。この問題集は実際試験の問題をすべて含めることができるだけでなく、問題集のソフト版は350-401シュミレーション問題集試験の雰囲気を完全にシミュレートすることもできます。Omgzlookの問題集を利用してから、試験を受けるときに簡単に対処し、楽に高い点数を取ることができます。

Cisco 350-401シュミレーション問題集 - まだ何を待っていますか。

多くのIT者がCiscoの350-401シュミレーション問題集認定試験を通してIT業界の中で良い就職機会を得たくて、生活水準も向上させたいです。でも多くの人が合格するために大量の時間とエネルギーをかかって、無駄になります。同等の効果は、Omgzlookは君の貴重な時間とお金を節約するだけでなく100%の合格率を保証いたします。もし弊社の商品が君にとっては何も役割にならなくて全額で返金いたいます。

それは正確性が高くて、カバー率も広いです。あなたはOmgzlookの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

OmgzlookはCiscoのWGU Organizational-Behaviors-and-Leadershipの認定試験を真実に、全面的に研究したサイトです。 もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoのNetwork Appliance NS0-528試験のソフトウェアです。 CompTIA N10-009 - OmgzlookはIT領域の10年以上の認定経験を持っていますから、問題と解答に含まれています。 CiscoのEMC D-VXR-OE-23の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのEMC D-VXR-OE-23試験に一番信頼できるヘルプを提供します。 Omgzlook CiscoのAACN CCRN-Adult試験スタディガイドはあなたのキャリアの灯台になれます。

Updated: May 28, 2022