あなたの夢は何ですか。あなたのキャリアでいくつかの輝かしい業績を行うことを望まないのですか。きっと望んでいるでしょう。 あなたの利用するCiscoの350-401シュミレーション問題集ソフトが最新版のを保証するために、一年間の無料更新を提供します。人々は異なる目標がありますが、我々はあなたにCiscoの350-401シュミレーション問題集試験に合格させるという同じ目標があります。 Omgzlookの350-401シュミレーション問題集教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。
CCNP Enterprise 350-401 もちろんありますよ。
あなたに安心にネットでCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)シュミレーション問題集試験の資料を購入させるために、我々Omgzlookは国際の最大の安全的な支払システムPaypalと協力してあなたの支払の安全性を保障します。 君がCiscoの350-401 日本語版問題解説問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401 日本語版問題解説問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。
この目標を実現するようには、我が社のOmgzlookは試験改革のとともにめざましく推進していき、最も専門的な350-401シュミレーション問題集問題集をリリースしています。現時点で我々のCisco 350-401シュミレーション問題集問題集を使用しているあなたは試験にうまくパースできると信じられます。心配なく我々の真題を利用してください。
Cisco 350-401シュミレーション問題集 - 我々もオンライン版とソフト版を提供します。
350-401シュミレーション問題集問題集は一年間で無料更新サービスを提供することができ、350-401シュミレーション問題集認定試験の合格に大変役に立ちます。そして、もし350-401シュミレーション問題集問題集の更新版があれば、お客様にお送りいたします。350-401シュミレーション問題集問題集は全面的かつわかりやすいです。あなたは350-401シュミレーション問題集問題集をちゃんと覚えると、350-401シュミレーション問題集試験に合格することは簡単です。では、試験を心配するより、今から行動しましょう。
我々OmgzlookはCiscoの350-401シュミレーション問題集試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401シュミレーション問題集試験問題集を開発するのに準備します。
350-401 PDF DEMO:
QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html
QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
携帯電話にブラウザをインストールでき、 私たちのEMC D-CSF-SC-23試験資料のApp版を使用することもできます。 ほんとんどお客様は我々OmgzlookのCisco IBM C1000-176問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。 EMC D-NWG-DS-00 - しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。 Microsoft MS-700-JPN問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。 Network Appliance NS0-516 - そして、Omgzlookに多くの受験生の歓迎されます。
Updated: May 28, 2022