350-401ウェブトレーニング - 350-401的中関連問題 & Implementing Cisco Enterprise Network Core Technologies 350-401 Encor - Omgzlook

もし運が良くないとき、失敗したら、お金を返してあなたの経済損失を減らします。我々社のチームは顧客のすべてのために、改革政策に伴って最新版の信頼できるCiscoの350-401ウェブトレーニングをリリースされて喜んでいます。我々社は350-401ウェブトレーニング問題集のクオリティーをずっと信じられますから、試験に失敗するとの全額返金を承諾します。 なぜなら、それはCiscoの350-401ウェブトレーニング認定試験に関する必要なものを含まれるからです。Omgzlookを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。 次のジョブプロモーション、プロジェクタとチャンスを申し込むとき、Cisco 350-401ウェブトレーニング資格認定はライバルに先立つのを助け、あなたの大業を成し遂げられます。

CCNP Enterprise 350-401 それは正確性が高くて、カバー率も広いです。

つまり350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ウェブトレーニング練習問題はあなたの最も正しい選択です。 我々はあなたに提供するのは最新で一番全面的なCiscoの350-401 試験復習赤本問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401 試験復習赤本試験のソフトウェアの更新です。無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの350-401 試験復習赤本試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。

だから、350-401ウェブトレーニング復習教材を買いました。本当に助かりました。先月、350-401ウェブトレーニング試験に参加しました。

Cisco 350-401ウェブトレーニング - こうして、君は安心で試験の準備を行ってください。

Ciscoの350-401ウェブトレーニングの試験の資料やほかのトレーニング資料を提供しているサイトがたくさんありますが、Ciscoの350-401ウェブトレーニングの認証試験の高品質の資料を提供しているユニークなサイトはOmgzlookです。Omgzlookのガイダンスとヘルプを通して、初めにCiscoの350-401ウェブトレーニング「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の認証を受けるあなたは、気楽に試験に合格すことができます。Omgzlookが提供した問題と解答は現代の活力がみなぎる情報技術専門家が豊富な知識と実践経験を活かして研究した成果で、あなたが将来IT分野でより高いレベルに達することに助けを差し上げます。

Cisco 350-401ウェブトレーニング「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401ウェブトレーニング証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

その中で、Omgzlookが他のサイトをずっと先んじてとても人気があるのは、OmgzlookのCiscoのFortinet NSE5_FSM-6.3試験トレーニング資料が本当に人々に恩恵をもたらすことができて、速く自分の夢を実現することにヘルプを差し上げられますから。 VMware 3V0-42.23 - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 Omgzlookが提供したCiscoのCompTIA 220-1102トレーニング資料を利用してから試験に合格することがとてもたやすことになって、これは今までがないことです。 SAP C_THR82_2405 - 試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。 EMC D-PSC-DY-23 - IT認証はIT業種での競争な手段の一つです。

Updated: May 28, 2022