OmgzlookのCiscoの200-301的中関連問題試験問題資料は質が良くて値段が安い製品です。我々は低い価格と高品質の模擬問題で受験生の皆様に捧げています。我々は心からあなたが首尾よく試験に合格することを願っています。 OmgzlookのCiscoの200-301的中関連問題試験トレーニング資料は信頼できるもので、１００パーセントの合格率を保証します。難しいIT認証試験に受かることを選んだら、頑張って準備すべきです。 Ciscoの200-301的中関連問題認定試験は実は技術専門家を認証する試験です。
CCNA 200-301 」とゴーリキーは述べました。
CCNA 200-301的中関連問題 - Cisco Certified Network Associate Exam それに、万一の場合、問題集を利用してからやはり試験に失敗すれば、Omgzlookは全額返金のことを約束します。 あなたの夢は何ですか。あなたのキャリアでいくつかの輝かしい業績を行うことを望まないのですか。
ここで言いたいのは、どのようにすれば効率的に200-301的中関連問題認定試験の準備をして一回で試験に合格できるのかということです。Ciscoの認定試験は現在とても人気がある試験ですね。この重要な認証資格をもうすでに手に入れましたか。
Cisco 200-301的中関連問題 - 我々もオンライン版とソフト版を提供します。
商品を購入するとき、信頼できる会社を選ぶことができます。我々OmgzlookはCiscoの200-301的中関連問題試験の最高の通過率を保証してCiscoの200-301的中関連問題ソフトの無料のデモと一年間の無料更新を承諾します。あなたに安心させるために、我々はあなたがCiscoの200-301的中関連問題試験に失敗したら全額で返金するのを保証します。OmgzlookはあなたのCiscoの200-301的中関連問題試験を準備する間あなたの最もよい友達です。
我々OmgzlookはCiscoの200-301的中関連問題試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の200-301的中関連問題試験問題集を開発するのに準備します。
200-301 PDF DEMO:
QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 4
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
弊社はSAP C-THR81-2405問題集の英語版と日本語版をリリースしています。 ほんとんどお客様は我々OmgzlookのCisco Salesforce Sales-Cloud-Consultant問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。 SAP C_THR84_2405 - 購入した後、一年間の無料サービス更新を提供します。 Citrix 1Y0-341問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。 我々社のAmazon ANS-C01-KR問題集を参考した後、ほっとしました。
Updated: May 28, 2022