Omgzlookが提供して差し上げたのは高品質のCiscoの200-301的中率「Cisco Certified Network Associate Exam」模擬問題集で、あなたがステップバイステップで試験に準備する手順を指導しています。OmgzlookのCiscoの200-301的中率試験問題集は絶対あなたに成功をもたらすことを保証します。OmgzlookのCiscoの200-301的中率認定試験に準備するために色々な方法がありますが、 Omgzlookの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの200-301的中率認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。 しかし準備しなければならないのですから、落ち着かない心理になりました。
CCNA 200-301 ITが好きですか。
CCNA 200-301的中率 - Cisco Certified Network Associate Exam Omgzlookは優れたIT情報のソースを提供するサイトです。 IT認定試験の中でどんな試験を受けても、Omgzlookの200-301 関連資格試験対応試験参考資料はあなたに大きなヘルプを与えることができます。それは Omgzlookの200-301 関連資格試験対応問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。
これは試験の準備をするために非常に効率的なツールですから。この問題集はあなたが少ない労力で最高の結果を取得することができます。OmgzlookはIT認定試験を受験した多くの人々を助けました。
それはOmgzlookのCisco 200-301的中率問題集です。
Omgzlookは専門的で、たくさんの受験生のために、君だけのために存在するのです。それは正確的な試験の内容を保証しますし、良いサービスで、安い価格で営業します。Omgzlookがあれば、Ciscoの200-301的中率試験に合格するのは心配しません。Omgzlookは君が最も早い時間でCiscoの200-301的中率試験に合格するのを助けます。私たちは君がITエリートになるのに頑張ります。
Omgzlookは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。
200-301 PDF DEMO:
QUESTION NO: 1
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html
QUESTION NO: 2
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html
QUESTION NO: 3
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html
QUESTION NO: 4
Refer to the exhibit. After you apply the given configuration to arouter, the DHCP clients behind the device connot communicate with hosts outside of their subnet.
Which action is most likely to correct the problem?
A. configure the default gateway
B. Configure the dns server on the same subnet as the clients
C. Activate the dhcp pool
D. Correct the subnet mask
Answer: A
QUESTION NO: 5
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
Omgzlookでは、私たちは君のすべての夢を叶えさせて、君の最も早い時間でCiscoのHP HPE7-A04認定試験に合格するということを保証します。 うちのCiscoのCitrix 1Y0-341試験トレーニング資料を購入する前に、Omgzlookのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。 Microsoft MS-700 - もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、Omgzlookは無料でサンプルを提供することができます。 HP HP2-I74 - 時間とお金の集まりより正しい方法がもっと大切です。 弊社のOmgzlookで無料でCiscoのMicrosoft PL-200Jソフトのデモを直ちにダウンロードできます。
Updated: May 28, 2022